Correction to Operation and Maintenance Manual , "Equipment Lowering with Engine Stopped" {7000}
- Landfill Compactor:
- 836G (S/N: BRL1-UP; 7MZ1-UP)
- Wheel Tractor:
- 834G (S/N: BPC1-UP; 6GZ1-UP)
The following information should be added to the information that is found in the operation section.
Show/hide table
 | |
| Illustration 1 | g00933394 |
Location of the access hole for the ball valve | |
Show/hide table
 | |
| Illustration 2 | g00931690 |
The control valve for the 834G Wheel Tractor is shown. The control valve for the 836G Landfill Compactor is similar. | |
If the work tool will not lower, a problem may exist with the pilot valve. A ball valve is located near the right rear side of the main control valve. The ball valve can be accessed through a hole in the cover for the main control valve. The ball valve (1) is used for lowering the work tool. Rotate the valve until the slot in the valve is parallel to the line in order to lower the work tool.
Caterpillar Information System:
Bench Test Procedure for Hydraulic Piston Pumps {4268, 4306, 5070} Bench Test Procedure for Hydraulic Piston Pumps {4268, 4306, 5070}
2002/10/28 New Friction Disc Improves The Service Life Of The Drive Shaft Group Components {3253}
637G Wheel Tractor-Scraper Wheel Scraper Power Train Radiator Module
D10R Track-Type Tractor Bulldozer - Lubricate
Test Sequence for Capsule Type Fuel Nozzles{0782} Test Sequence for Capsule Type Fuel Nozzles{0782}
3054E Industrial Engine Camshaft Bearings - Remove and Install
D10R Track-Type Tractor Alternator and Fan Belts - Inspect/Adjust/Replace
D10R Track-Type Tractor Air Conditioner Belt - Inspect/Adjust/Replace
D10R Track-Type Tractor Bulldozer Tilt Brace
631G and 637G Wheel Tractor-Scrapers Hydraulic System Control Valve (Push-Pull)
Rerouting the Return-to-Tank Fuel Line{1274} Rerouting the Return-to-Tank Fuel Line{1274}
631G Wheel Tractor-Scraper Capacities (Refill)
631G and 637G Wheel Tractor-Scrapers Hydraulic System Apron
2002/10/28 Examine Failed Starting Motors to Understand the Reason for Failure {1453}
631G and 637G Wheel Tractor-Scrapers Hydraulic System Apron
938G Wheel Loader, 938G Series II Wheel Loader, IT38G Integrated Toolcarrier and IT38G Series II Integrated Toolcarrier Traction Control System Test/Enable Switch
C15 Petroleum Generator Set Engines Electric Starting Motor
2002/10/28 Correction to Operation and Maintenance Manual , "Equipment Lowering with Engine Stopped" {7000}
631G and 637G Wheel Tractor-Scrapers Machine Systems Bail Cylinder and Mounting
3126B Machine Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
D10R Main Frame and Fender Crossbeam Pinned Mount Conversion{7050} D10R Main Frame and Fender Crossbeam Pinned Mount Conversion{7050}
D10R Track-Type Tractor Safety Messages
631G and 637G Wheel Tractor-Scrapers Hydraulic System Bail Cylinder
3054E Industrial Engine Flywheel - Remove