CID 0042 FMI 07 Injector Actuation Valve improper response
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects the following conditions:
- The engine is running and the ECM detects coolant temperature that is less than 25 °C (77 °F).
System Response:
The ECM will log the diagnostic code. The ECM flags injection actuation pressure as invalid data and a default value is used.
- The engine may misfire and/or shutdown
- The engine may experience reduced speed (rpm) and/or low power.
Test Step 1. Perform the following diagnostic procedure: Injection Actuation Pressure Control Valve Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
3500 Generator Sets Product Description
C9 Generator Set Engines Fuel System Pressure - Test
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Filter Base
2005/03/28 A New Fuel Shield is Available {1252}
C12 Marine Engine Cooling System
C9 Engines for Caterpillar Built Machines Water Pump - Disassemble
G3400 Engines (EIS) Detonation
XQ125 Generator Set Alternator and Fan Belts - Replace
C27 and C32 Industrial and Petroleum Engines Cooling System
G3400 Engines (EIS) Troubleshooting Data Sheet
C4.4 Marine Generator Set Engine Oil and Filter - Change
C27 and C32 Industrial and Petroleum Engines Air Inlet and Exhaust System
C15 Generator Set Engines CID 0102 FMI 03 Boost Pressure Sensor short to +batt
C15 Generator Set Engines CID 0102 FMI 04 Boost Pressure Sensor short to ground
C9 Marine Auxiliary and Marine Generator Set Engines CID 0164 FMI 01 Injector Actuation Pressure below normal
C9 Marine Auxiliary and Marine Generator Set Engines CID 0269 FMI 03 Sensor Supply too high
C9 Marine Auxiliary and Marine Generator Set Engines Event Codes
C9 Engines for Caterpillar Built Machines Water Pump - Assemble
C15 and C18 Engines for Caterpillar Built Machines E198 Low Fuel Pressure
C280 Marine and Petroleum Engines Turbocharger
C9 Engines for Caterpillar Built Machines Cylinder Head - Remove
C-12 Generator Set Engine E362 Engine Overspeed
C27 and C32 Industrial and Petroleum Engines Air Inlet and Exhaust Lines
C18 Marine Generator Set Starting the Engine