CID 0164 FMI 01 Injector Actuation Pressure below normal
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects all of the following conditions:
- Engine speed is greater than zero rpm.
- No diagnostics for +5 V sensor supply are active.
- No diagnostic codes for the injection actuation pressure are active.
- No injection actuation outputs are active.
- Cold mode is not active.
- Actual injection actuation pressure is above 26.5 MPa (3850 psi) for at least six seconds or injection actuation pressure is consistently under the acceptable low value.
System Response:
The ECM will log the diagnostic code. The engine will revert to a default torque map.
Low power
Test Step 1. Perform the following diagnostic procedure: Injection Actuation Pressure - Test
Results:
- OK - STOP
Caterpillar Information System:
C15 Generator Set Engines CID 0102 FMI 04 Boost Pressure Sensor short to ground
C15 Generator Set Engines CID 0102 FMI 03 Boost Pressure Sensor short to +batt
C9 Marine Auxiliary and Marine Generator Set Engines CID 0042 FMI 07 Injector Actuation Valve improper response
3500 Generator Sets Product Description
C9 Generator Set Engines Fuel System Pressure - Test
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Filter Base
2005/03/28 A New Fuel Shield is Available {1252}
C12 Marine Engine Cooling System
C9 Engines for Caterpillar Built Machines Water Pump - Disassemble
G3400 Engines (EIS) Detonation
XQ125 Generator Set Alternator and Fan Belts - Replace
C27 and C32 Industrial and Petroleum Engines Cooling System
C9 Marine Auxiliary and Marine Generator Set Engines CID 0269 FMI 03 Sensor Supply too high
C9 Marine Auxiliary and Marine Generator Set Engines Event Codes
C9 Engines for Caterpillar Built Machines Water Pump - Assemble
C15 and C18 Engines for Caterpillar Built Machines E198 Low Fuel Pressure
C280 Marine and Petroleum Engines Turbocharger
C9 Engines for Caterpillar Built Machines Cylinder Head - Remove
C-12 Generator Set Engine E362 Engine Overspeed
C27 and C32 Industrial and Petroleum Engines Air Inlet and Exhaust Lines
C18 Marine Generator Set Starting the Engine
C18 Marine Generator Set Cold Weather Starting
C9 Engines for Caterpillar Built Machines Cylinder Head - Install
C18 Marine Generator Set Manual Stop Procedure