MID 036 - CID 0827 - FMI 08 Left Exhaust Temperature signal abnormal
产生此代码的情况:
电子控制模块（ECM）已通电三秒钟。 当前没有诊断代码 263-03 和 263-04。 传感器频率高于 1000 赫兹或低于 150 赫兹。 占空比大于 90% 或小于 10%。
系统响应:
以上 CID-FMI 代码记录在存储器中。 在卡特彼勒电子技师（ET）的状态屏幕上，该参数会显示为无效数据。
测试步骤 1. 进行以下的诊断步骤: "发动机传感器断路/短路测试"
结果:
- 正常 - 停止
- 已修复，正常。 - 停止
Caterpillar Information System:
Repair of Cracks in Rear Track Roller Frame{4151} Repair of Cracks in Rear Track Roller Frame{4151}
3500B Engines Engine Oil Cooler - Assemble
D9R Track-Type Tractor Cooling System Water Temperature Regulator - Replace
994D Wheel Loader Machine System Temperature Sensor (Ambient Air) - Remove and Install
D9R Track-Type Tractor Air Conditioner In-Line Dryer - Replace
994D Wheel Loader Machine System VIDS/VIMS Interface Module - Remove and Install
D9R Track-Type Tractor Air Conditioner In-Line Dryer - Inspect
994D Wheel Loader Machine System Oil Filter (Front Pump Drive Lubrication) - Remove and Install
994D Wheel Loader Machine System Lubrication Pump (Automatic) - Remove and Install
3500B Engines Engine Oil Cooler - Disassemble
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0545 - FMI 05 Ether Start Relay open/short to +batt
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0545 - FMI 06 Ether Start Relay short to ground
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0261 - FMI 13 Engine Timing calibration required
545 Wheel Skidder Power Train Drive Shaft (Front) - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Compression - Test
3176C and 3196 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
994D Wheel Loader Machine System Gear Pump (Steering and Brake Oil Cooler) - Assemble
545 Wheel Skidder Power Train Drive Shaft (Center) - Remove and Install
613C Series II Wheel Tractor-Scraper Hydraulic System Draft Frame
561N, 572R Series II and 572R Pipelayers and D10R, D11R, D5M, D5N, D6M, D6N, D6R, D6R Series II, D7R, D7R Series II and D8R Series II Track-Type Tractors Power Train Electronic Control System Calibration Operation
3408E and 3412E Engines for Caterpillar Built Machines Cooling System - Inspect
3176C and 3196 Engines for Caterpillar Built Machines Cooling System - Test
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Injection Pump - Install
C15 Petroleum Generator Set Engines Water Temperature Regulator - Test