3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Caterpillar

Removal Procedure

Start By:

1. Remove the fuel injection lines, if necessary. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".

Show/hide table

Disconnect batteries before performance of any service work.

Show/hide table

NOTICE
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.

Show/hide table



Illustration 1	g00587937

1. Remove nuts (1) and the washers from the terminal on the glow plugs.

2. Remove bus bar (2) from the glow plugs.

Show/hide table



Illustration 2	g00588004

3. Remove glow plugs (3) from the cylinder head.

Installation Procedure

Show/hide table

NOTICE
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.

Show/hide table



Illustration 3	g00588004

1. Install glow plugs (3) in the cylinder head. Tighten the glow plugs to a torque of 17 N·m (13 lb ft).

Show/hide table



Illustration 4	g00587937

2. Install bus bar (2) on the glow plugs.

3. Install the washers and nuts (1) on the glow plugs. Tighten the nuts (1) to a torque of 17 N·m (13 lb ft).

End By: Install the fuel injection lines, if necessary. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".