Valve Mechanism Cover - Remove and Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 从气门机构盖上卸下呼吸器管 (1)。
- 卸下螺栓 (2) 和气门机构盖 (3)。
Show/hide table
图 1 | g01046114 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将气门机构盖 (3) 安置在气门机构盖底座上。 安装螺栓 (2)。 按数字顺序拧紧螺栓至扭矩为
18 ± 3 N·m (13 ± 2 lb ft) 。 - 将呼吸器管 (1) 安装在气门机构盖上。
Show/hide table
图 2 | g01046114 |
Show/hide table
图 3 | g00579295 |
Caterpillar Information System:
C11 and C13 Engines for Caterpillar Built Machines Sensors and Electrical Connectors
3508B, 3512B and 3516B Generator Set Engines Exhaust Manifold - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Front Cover - Install
C9 Marine Generator Set Belts - Inspect/Adjust/Replace
C15 and C18 Engines for Caterpillar Built Machines Front Cover - Remove
C15 and C18 Tier 4 Final Engines Turbocharger - Inspect
C15 and C18 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
C15 and C18 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
3126B Petroleum Engine Piston and Rings
2004/11/01 A New Process Helps Prevent Freezing {1063, 1064}
3412E Petroleum Engine Piston and Rings
C15 and C18 Generator Set Engines Crankshaft Rear Seal - Install
C15 and C18 Engines for Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
C-10 Petroleum Engine Valve Mechanism Cover
C3.3 and C4.4 Generator Sets Fuel System Primary Filter/Water Separator - Drain
C15 and C18 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove
C15 and C18 Tier 4 Final Engines Cooling System - Check - Overheating
C-10 Petroleum Engine Turbocharger
C15 and C18 Engines for Caterpillar Built Machines Camshaft - Remove
C15 and C18 Engines for Caterpillar Built Machines Camshaft - Install
C-10 Petroleum Engine Exhaust Manifold
C15 and C18 Engines for Caterpillar Built Machines Fuel Filter Pressure Differential Switch
C15 and C18 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
3412E Petroleum Engine General Information