Front Cover - Install
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将密封和前齿轮室盖 (2) 安置在螺柱 (3) 上。
- 安装半圆头螺钉 (1)。 拧紧半圆头螺钉至扭矩为
21 ± 3 N·m (15 ± 2 lb ft) 。 - 将隔套 (4) 和螺母 (5) 安装在螺柱 (3) 上。
Show/hide table
| |
| 图 1 | g01007036 |
Caterpillar Information System:
C9 Marine Generator Set Belts - Inspect/Adjust/Replace
C15 and C18 Engines for Caterpillar Built Machines Front Cover - Remove
C15 and C18 Tier 4 Final Engines Turbocharger - Inspect
C15 and C18 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
C15 and C18 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
3126B Petroleum Engine Piston and Rings
2004/11/01 A New Process Helps Prevent Freezing {1063, 1064}
3412E Petroleum Engine Piston and Rings
C15 and C18 Generator Set Engines Crankshaft Rear Seal - Install
G3300 Engines Maintenance Log
C11 and C13 Engines Engine Oil Pan
3126B Petroleum Engine Exhaust Manifold
3508B, 3512B and 3516B Generator Set Engines Exhaust Manifold - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Sensors and Electrical Connectors
C15 and C18 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
C-10 Petroleum Engine Valve Mechanism Cover
C3.3 and C4.4 Generator Sets Fuel System Primary Filter/Water Separator - Drain
C15 and C18 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove
C15 and C18 Tier 4 Final Engines Cooling System - Check - Overheating
C-10 Petroleum Engine Turbocharger
C15 and C18 Engines for Caterpillar Built Machines Camshaft - Remove
C15 and C18 Engines for Caterpillar Built Machines Camshaft - Install
C-10 Petroleum Engine Exhaust Manifold