Change In Repair Centers For 5P2160 Horsepower Meter Group{0651}
Usage:
A change has been made to the repair centers for the 5P2148 Fuel Flow Meter and the 5P2150 Horsepower Meter Display which are components of the 5P2160 Horsepower Meter Group. These two components will now only be repaired in the U.S.A. For repairs or information about repairs they must be sent to:
Fluidyne Instrumentation
2930 Lakeshore Avenue
Oakland, CA 94610
U.S.A.
Telephone: 415-444-2379
Telex: 33-7769
Caterpillar Information System:
1983/01/24 New Expansion Tank And Support Used{1354}
1983/01/24 Corrections To Product Update Guide (Form PEGP2808) And Engine Update Guide (Form PEGP2811){0374}
1983/01/24 Improved Cylinder Head Gasket{1101,1201}
1983/01/24 Identification Of Exchange Or Reconditioned Components{0610,0351}
1983/01/24 Low Manifold Pressure: New Gasket Prevents Air Leakage At Aftercooler{1063}
1983/01/17 Correction To Fuel Injection Test Bench Book, Form SEHS7466{0652,0374}
1983/01/17 Parts Service Information For Pistons And Rings{1214,1215}
1983/01/17 Revision Of Test Specification Tolerance For 1P1795 Master Valve Assembly{0652,1250}
1983/01/17 Disconnect Fuel Lines And Install Caps Before Unit Injectors Are Removed{1274,1254,1251}
1983/01/17 Improved Mounting Assembly For Speed Switch Contactor Group{7418}
1983/01/17 New Sealant Used Between The Fuel Injection Pump/Governor Drive Housing And Cylinder Block{1288}
1983/01/17 Improved Valve Covers Used{1107}
1983/01/31 Service Information For Hydramechanical Shutoff Units{7418}
1983/01/31 Parts Service Information For Pistons{1214,1225}
1983/01/31 Know What Type Of Repair To Make And When{0374}
1983/01/31 Notice: Bolts, Washers Can Fall Into Suction Screen Housing And Damage Oil Pump{1302}
1983/01/31 FT806 Cylinder Head Repair Bench Group Is Improved{1101,1201}
1983/01/31 Special Instruction Available For "Troubleshooting And Repair Of The 6V2100 Multitach"{0651}
1983/02/14 New Clutches For Rear Power Take-Off{3055,3054}
1983/02/14 Check Cylinder Bores For Chamfer During Reconditioning{1202,1222,1223}
1983/02/14 New Water Pump Has Improved Seal{1361}
1983/02/28 Test Procedure For Hydramechanical Shutoff After Engine Storage{7418}
1983/02/28 New Specifications For Installation Of Crankshaft Counterweight Bolts{1202}
1983/02/28 Use FT1783 Fixture To Drill Vent Holes In Impeller{0665,1361}