New Expansion Tank And Support Used{1354}
Usage:
All 3508, 3512 And 3516 Industrial, Marine And Generator Set Engines
Description of Change: A new expansion tank assembly and a new support assembly are used in the expansion tank group on the above engines. New mounting bolts are also used with the new support assembly.
The new tank assembly has an added bottom plate to prevent cracks in the mounting bosses. It also has added supports on the inside to decrease stresses on the joints at the edges and to prevent expansion of the tank.
Adaptable As: The new parts are direct replacements for the former parts as shown in the chart.
Caterpillar Information System:
1983/01/24 Corrections To Product Update Guide (Form PEGP2808) And Engine Update Guide (Form PEGP2811){0374}
1983/01/24 Improved Cylinder Head Gasket{1101,1201}
1983/01/24 Identification Of Exchange Or Reconditioned Components{0610,0351}
1983/01/24 Low Manifold Pressure: New Gasket Prevents Air Leakage At Aftercooler{1063}
1983/01/17 Correction To Fuel Injection Test Bench Book, Form SEHS7466{0652,0374}
1983/01/17 Parts Service Information For Pistons And Rings{1214,1215}
1983/01/17 Revision Of Test Specification Tolerance For 1P1795 Master Valve Assembly{0652,1250}
1983/01/17 Disconnect Fuel Lines And Install Caps Before Unit Injectors Are Removed{1274,1254,1251}
1983/01/17 Improved Mounting Assembly For Speed Switch Contactor Group{7418}
1983/01/17 New Sealant Used Between The Fuel Injection Pump/Governor Drive Housing And Cylinder Block{1288}
1983/01/17 Improved Valve Covers Used{1107}
1983/01/17 New Clutch Retraction Pins And Seals{3302}
1983/01/31 Change In Repair Centers For 5P2160 Horsepower Meter Group{0651}
1983/01/31 Service Information For Hydramechanical Shutoff Units{7418}
1983/01/31 Parts Service Information For Pistons{1214,1225}
1983/01/31 Know What Type Of Repair To Make And When{0374}
1983/01/31 Notice: Bolts, Washers Can Fall Into Suction Screen Housing And Damage Oil Pump{1302}
1983/01/31 FT806 Cylinder Head Repair Bench Group Is Improved{1101,1201}
1983/01/31 Special Instruction Available For "Troubleshooting And Repair Of The 6V2100 Multitach"{0651}
1983/02/14 New Clutches For Rear Power Take-Off{3055,3054}
1983/02/14 Check Cylinder Bores For Chamfer During Reconditioning{1202,1222,1223}
1983/02/14 New Water Pump Has Improved Seal{1361}
1983/02/28 Test Procedure For Hydramechanical Shutoff After Engine Storage{7418}
1983/02/28 New Specifications For Installation Of Crankshaft Counterweight Bolts{1202}