Equalizer Bar Center Pin - Lubricate
Show/hide table
| NOTICE |
|---|
Apply lubricant to the fittings with a hand operated grease gun only. Use of pressure operated lubricating equipment damages the seals. |
Show/hide table
 | |
| Illustration 1 | g00102949 |
Lubricate the equalizer bar center pin through the two remote fittings, if equipped. If equipped, the fittings will be located inside the engine compartment on the left side of the machine.
Caterpillar Information System:
992G Wheel Loader and 854G Wheel Dozer Power Train Fixed Axle (Front)
651E Wheel Tractor-Scraper Radiator Core - Clean
D5M Track-Type Tractor Engine Oil and Filter - Change
D5M Track-Type Tractor Engine Oil Level - Check
631E Series II Wheel Tractor-Scrapers Warranty Information
D5M Track-Type Tractor Engine Air Precleaner - Clean
992G Wheel Loader and 854G Wheel Dozer Power Train Input Drive Shaft
D6M Track-Type Tractor Power Train Torque Converter
D5M Track-Type Tractor Engine Air Filter Secondary Element - Replace
D5M Track-Type Tractor Engine Air Filter Primary Element - Clean/Replace
D5M Track-Type Tractor Cutting Edges and End Bits
992G Wheel Loader and 854G Wheel Dozer Power Train Drive Shaft
992G Wheel Loader and 854G Wheel Dozer Braking System Brake Control Valve (Parking)
D5M Track-Type Tractor Equalizer Bar Pins - Inspect
D5M Track-Type Tractor Equalizer Bar Pins - Lubricate
D5M Track-Type Tractor Ether Starting Aid Cylinder - Replace
D6M Track-Type Tractor Power Train Transmission - Power Shift
D5M Track-Type Tractor Fuel Tank Water and Sediment - Drain
651E Wheel Tractor-Scraper Router Bits - Inspect/Replace
D6R Track-Type Tractor Crushing Prevention and Cutting Prevention
D6R Track-Type Tractor Fire Prevention and Explosion Prevention
D6M Track-Type Tractor Bulldozer Blade Tilt and Angle Control
992G Wheel Loader and 854G Wheel Dozer Power Train Oscillating Axle (Rear)
3208 Marine Engine Crushing Prevention and Cutting Prevention