Engine Oil and Filter - Change
Show/hide table
 |
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. |
 |
Show/hide table
 | |
| Illustration 1 | g00102934 |
- Remove the crankcase drain access cover, which is in the crankcase guard.
- Remove the crankcase drain plug. Allow the oil to drain into a suitable container.
- Remove the crankcase oil filter element and discard the crankcase oil filter element properly. Make sure that all of the old filter seal is removed from the filter base.
Show/hide table
 | |
| Illustration 2 | g00101120 |
- Apply a thin coat of oil to the new filter seal. Install the new crankcase oil filter element by hand. When the gasket contacts the filter base, tighten the filter element by an additional turn of 270 degrees. Rotation index marks are on the new filter element. These rotation index marks are spaced at 90 degree intervals. Use these rotation index marks as a guide for proper tightening.
- Install the crankcase drain plug.
- Remove oil filler cap (1). Fill the crankcase with new oil. See Operation and Maintenance Manual, "Refill Capacities". Clean the oil filler cap and install the oil filler cap.
Show/hide table
 | |
| Illustration 3 | g00101125 |
- Always measure the oil level with dipstick (2) in order to ensure that the correct amount of oil was added.
- On the dipstick, maintain the oil level between the "ADD" mark and "FULL" mark.
Caterpillar Information System:
D5M Track-Type Tractor Engine Oil Level - Check
631E Series II Wheel Tractor-Scrapers Warranty Information
D5M Track-Type Tractor Engine Air Precleaner - Clean
992G Wheel Loader and 854G Wheel Dozer Power Train Input Drive Shaft
D6M Track-Type Tractor Power Train Torque Converter
D5M Track-Type Tractor Engine Air Filter Secondary Element - Replace
D5M Track-Type Tractor Engine Air Filter Primary Element - Clean/Replace
D5M Track-Type Tractor Cutting Edges and End Bits
992G Wheel Loader and 854G Wheel Dozer Power Train Drive Shaft
D5M Track-Type Tractor Cooling System Level - Check
D5M Track-Type Tractor Caterpillar Reference Material
D5M Track-Type Tractor Mounting and Dismounting
651E Wheel Tractor-Scraper Radiator Core - Clean
992G Wheel Loader and 854G Wheel Dozer Power Train Fixed Axle (Front)
D5M Track-Type Tractor Equalizer Bar Center Pin - Lubricate
992G Wheel Loader and 854G Wheel Dozer Braking System Brake Control Valve (Parking)
D5M Track-Type Tractor Equalizer Bar Pins - Inspect
D5M Track-Type Tractor Equalizer Bar Pins - Lubricate
D5M Track-Type Tractor Ether Starting Aid Cylinder - Replace
D6M Track-Type Tractor Power Train Transmission - Power Shift
D5M Track-Type Tractor Fuel Tank Water and Sediment - Drain
651E Wheel Tractor-Scraper Router Bits - Inspect/Replace
D6R Track-Type Tractor Crushing Prevention and Cutting Prevention
D6R Track-Type Tractor Fire Prevention and Explosion Prevention