Start By:
- Remove the air compressor, if necessary. Refer to Disassembly and Assembly, "Air Compressor - Remove and Install".
- Remove the camshaft gear. Refer to Disassembly and Assembly, "Camshaft Gear - Remove and Install".
- Remove the crankshaft front seal and the wear sleeve. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Remove".
- Remove the pump drive, if necessary. Refer to Disassembly and Assembly, "Pump Drive - Remove".
- Remove the auxiliary water pump, if necessary. Refer to Disassembly and Assembly, "Auxiliary Water Pump - Remove".
- Remove the camshaft position sensor. Refer to Disassembly and Assembly, "Camshaft Position Sensor - Remove and Install".
- Remove the crankshaft position sensor. Refer to Disassembly and Assembly, "Crankshaft Position Sensor - Remove and Install".
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Do not turn the crankshaft or the camshaft while the camshaft gear is removed. If the front gear group is not correctly timed during installation, interference can occur between the pistons and the valves, resulting in damage to the engine. |
- If necessary, remove the accessory drive from the front housing.
Show/hide table
Illustration 1 g01067630 - Remove bolts (3) and bracket (4).
- Remove bolts (6).
- Remove bolts (2) and clips (1) and (5).
- Remove nuts (7) and washers. Remove cover (8).
Show/hide table
Illustration 2 g01067628 - Remove bolts (9) and strap (10) from the cylinder head and front housing (15).
- Remove bolt (12).
- Remove the nut from stud (11).
- Remove bolts (13) from the front housing.
- Remove nuts (14) from the front housing.
- Remove bolts (16) from the front housing.
Show/hide table
Illustration 3 g01067629 - Loosen bolts (19) from the engine oil pan.
Note: It is not necessary to remove the engine oil pan from the engine.
- Remove front housing (15).
- Remove gasket (17) from plate (18) and front housing (15).