Engine Oil Filter Base
Show/hide table
Illustration 1 | g01058902 |
(1) 4N-8150 Spring
- Length under test force ... 55.25 mm (2.175 inch)
- Test force ... 76 ± 5.8 N (17 ± 1.30 lb)
- Free length after test ... 93.7 mm (3.69 inch)
- Outside diameter ... 20.6 mm (0.81 inch)
- The filter bypass and the cooler bypass valves will open with the following pressure difference. ... 255 ± 20 kPa (37 ± 3 psi)
- Test force ... 76 ± 5.8 N (17 ± 1.30 lb)
(2) Oil Filter Adapter
Show/hide table
Illustration 2 | g01059397 |
(3) Oil Filter Base
(4) Prior to installing the stud into the oil filter base, apply 9S-3263 Thread Lock Compound to the tapered end of the stud for the following length. ... 10.2 ± 1.5 mm (0.40 ± 0.06 inch)
Tighten the stud to the following torque. ... 80 ± 14 N·m (59 ± 10 lb ft)
(5) Apply engine oil to the seal of the oil filter. Put the oil filter in position. Turn the oil filter by hand until the seal makes contact with the base. Additionally tighten the oil filter by 3/4 of a turn.
Caterpillar Information System:
2004/03/01 The Piston Pin Retainer is Now Marked for Correct Orientation {1214}
C13, C15, and C18 Tier 4 Final Engines Flywheel
3412E Petroleum Engine Engine Speed/Timing Sensor - Calibrate
3406E, C-10 and C-12 On-highway Engines Check Engine Lamp or Warning Lamp Is Malfunctioning
3412E Petroleum Engine Throttle Position Sensor Circuit - Test
3412E Petroleum Engine Injector Solenoid Circuit - Test
3412E Petroleum Engine Injection Actuation Pressure Control Valve Circuit - Test
2004/05/01 Proper Documentation of Returned Parts within the Warranty Claim {1000}
SCJ and 8SC Series Alternators General Information
2004/05/01 Provide Proper Documentation of Returned Parts within the Warranty Claim {1000}
2004/03/22 Provide Proper Documentation of Returned Parts within the Warranty Claim {1000}
C15 and C18 Industrial Engines Vibration Damper and Pulley - Remove and Install
2004/04/01 223-9296 Alternators are Being Replaced. {1405}
SCJ and 8SC Series Alternators Alternator - Disassemble
C15 Petroleum Engines Air Compressor - Remove and Install
3406E, C-10 and C-12 On-highway Engines Cooling Fan Is Always ON
Electric Power Generation Principles General Information
C-10 and C-15 Petroleum Engines System Configuration Parameters
Electric Power Generation Principles Governor
3406E, C-10 and C-12 On-highway Engines Cruise Control, Idle, or PTO Can Not Be Set
C18 Marine Auxiliary Engines Injector Solenoid Circuit - Test
Electric Power Generation Principles Alternating Current Generator
3406E, C-10 and C-12 On-highway Engines Engine Cranks but Will Not Start
Electric Power Generation Principles Parallel Operation of Governors