Two Oil Change Kits Have Oil Filters, Cooling System Conditioner {1318,1350}
Usage:
1140, 1145, 1150, 1160, 3208 Truck Engines;
3145, 3150, 3160, 3208 Industrial And Generator Set Engines;
3160, 3208 Marine Engines
Two oil change kits are now available for the above engines.
The 6V3690 Oil Change Kit has two 9N5680 Oil Filters and a one-half pint bottle of 6V3542 Cooling System Conditioner. The 9N5680 Oil Filter has a bypass valve built in the filter. This kit is used on earlier engines as shown in the chart.
The 6V5875 Oil Change kit has two 8N9586 Oil Filters and a one-half pint bottle of 6V3542 Cooling System Conditioner. The 8N9586 Oil Filter has no bypass valve; the bypass valve is in the filter base on the engine. This kit is used on later engines as shown in the chart.
Caterpillar Information System:
1982/09/13 New Seal Rings Used In BrakeSavers {1155}
1982/09/13 New Bearing Used In Air Starting Motor {1451}
1982/09/06 New Instruction Card Available For 6V87 Valve Stem Gauge{0653}
1982/09/06 Reusability Of Camshaft Rollers And Roller Followers{1209,1210}
1982/09/06 Improved Inlet And Exhaust Valves{1105}
1982/09/06 New Brass Bonnet, Bonnet Assembly Used In Heat Exchanger{1379}
1982/09/06 Vacuum Tester Checks For Leaks Between Valve Face and Seat{0651,1103,1105}
1982/08/30 Make Sure Generator Leads Do Not Move Against Frame{4459}
1982/08/30 Added Methods To Decrease The Effects Of High Sulfur Fuels{1355,1280,1318,1000}
1982/08/30 Change Made To Installation Procedure For 3N5620 Service Disconnect Spacer Group{0374,1000}
1982/08/30 New Rear Support For Oil Cooler Is Thicker, Has Cast-In Spacers{1378}
1982/08/23 New Time Delay Conversion Groups Available{7400}
1982/09/13 New Water Pumps Use New Seal And Impeller {1361}
1982/09/13 Caterpillar-Built Industrial Engines Available In New Machines {0371,1000}
1982/09/13 New Rocker Arm Assemblies Used {1102}
1982/09/13 Seat Belt Hook Fasteners {7327}
1982/09/13 Improved Idler Pulley Assemblies For 3208 Engines {1156,1358,4306}
1982/09/20 FT1421 Spring Installer Makes Installation of Seat Suspension Springs Easier{7324,0622}
1982/09/20 New Meter Can Be Used To Check Wire Feed Rates During Weld Operations Of Undercarriage Components{0653}
1982/09/20 Improved Lubrication System{3311}
1982/09/20 New Recommendations For Track Roller Wear Before Rebuilding{4180,0662}
1982/09/20 Filler Cap Locks Prevent Vandalism (Damage) To Fluid Compartments{1273,1316,1382,3177,5056}
1982/09/20 Dial Bore Gauge And Size Setting Fixture Available{0653}
1982/09/20 Induction Bearing Heater Available{0627}