Usage:
start by:
a) remove floor plates
1. Remove cotter pin and pin (2) from rod end.
2. Remove cotter pin and washer (3) from pin. Remove flywheel clutch brake (1).
3. Remove four rivets (4) from shoe assembly. Remove facing (5).
Install Flywheel Clutch Brake (Direct Drive And Special Application)
1. Install a new facing on the shoe assembly.
2. Put the flywheel clutch brake in position over the brake drum and on the pin.
3. Install the pin, washers, and two cotter pins that hold the flywheel clutch brake in position.
4. Make an adjustment to the flywheel clutch brake as follows:
a) Release the flywheel clutch.
b) Loosen nut (4). Turn nut (2) until dimension (A) is 3.44 in. (87.38 mm). Tighten nut (4).
c) Loosen nut (3). Put the flywheel clutch control lever in the forward position. Turn bolt (1) until facing makes contact with the brake drum.
d) Release the flywheel clutch control lever. Turn bolt (1) clockwise two turns. Tighten nut (3).
end by:
a) install floor plates