Usage:
START BY:
a. remove fuel injection lines
1. Loosen hose clamp (3), and remove four bolts (2) and pipe assembly (1).
2. Remove bolts (4) and valve cover (5).
3. Remove bolt and breather assembly (6).
4. Disconnect nuts (7) from the fuel line adapter assemblies.
5. Remove fuel line adapter (9). Remove bolts (10) and valve cover base (8).
Install Valve Cover (Later)
1. Inspect gaskets and seals. Make a replacement if needed.
2. Install gasket (2) and valve cover base (1) on the cylinder head.
3. Tighten the bolts in the valve cover base in number sequence to a torque of 14 ± 3 N·m (10 ± 2 lb.ft.).
4. Put engine oil in the base adapter bores and on the seals (4). Install adapters (5). Connect fuel injection line nuts (3). Tighten fuel line nuts to a torque of 41 ± 7 N·m (30 ± 5 lb.ft.).
5. Install gasket (7) and valve cover (6).
6. Tighten the bolts in the valve cover in number sequence to a torque of 14 ± 3 N·m (10 ± 2 lb.ft.).
7. Install breather (8), and tighten bolt to a torque of 14 ± 3 N·m (10 ± 2 lb.ft.).
8. Install pipe assembly (9).
END BY:
a. install fuel injection lines