Usage:
Start By:
a. remove cylinder head
1. Remove water ferrules (1) from the spacer plate.
2. Remove O-ring seal (2) from the hollow dowel.
3. Remove spacer plate (3) from the cylinder block.
4. Remove O-ring seal (4) from the hollow dowel.
5. Remove spacer plate gasket (5) from the cylinder block.
Install Spacer Plate
1. Thoroughly clean the spacer plate and cylinder block surface.
2. Install a new spacer plate gasket (5) on the cylinder block. Install new O-ring seal (4) on the bottom of hollow dowel.
| NOTICE |
|---|
Both surfaces of spacer plate, top of cylinder block and both sides of the spacer plate gasket must be clean and dry. Do not use any gasket adhesives or other substances on these surfaces. |
3. Install spacer plate (3) on the cylinder block.
4. Check cylinder liner projection. See Install Cylinder Liners.
5. Install a new O-ring seal (2) on the top of hollow dowel.
6. Install new water ferrules (1) in the spacer plate.
End By:
a. install cylinder head