Fuel Transfer Pump - Remove
Removal Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove tube assembly (3) and tube assembly (2) from fuel transfer pump (1). Plug and cap all openings. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Show/hide table
 | |
| Illustration 1 | g00998298 |
- Remove bolts (5) and fuel transfer pump (1) from unit injector hydraulic pump (4) .
Show/hide table
 | |
| Illustration 2 | g00998906 |
- Remove O-ring seal (6) from the unit injector hydraulic pump. Inspect O-ring seal (6) for wear or damage. If the O-ring seal is worn or damaged, use a new part for replacement.
Show/hide table
 | |
| Illustration 3 | g00998860 |
- Remove the fittings for the fuel inlet port and the fuel outlet port from fuel transfer pump (1) .
Show/hide table
 | |
| Illustration 4 | g00998900 |
Caterpillar Information System:
G3520C and G3520E Generator Set Engines Flywheel Housing - Install
G3520C and G3520E Generator Set Engines Flywheel Housing - Remove
G3520C and G3520E Generator Set Engines Spark Plug - Remove and Install
3116 and 3126 Truck Engines Cylinder Head - Remove
3500B Marine Engines MID 036 - CID 0267 - FMI 04 Remote Shutdown Input short to ground
3500B Marine Engines MID 036 - CID 0267 - FMI 03 Remote Shutdown Input open/short to +batt
3500B Marine Engines MID 036 - CID 0267 - FMI 02 Incorrect Engine Shutdown Switch inputs
2003/06/01 SOLAS Requirement for Screening Fuel and Oil Line Connections on Marine Engines {1274, 1307}
G3520C and G3520E Generator Set Engines Exhaust Manifold - Install
G3520C and G3520E Generator Set Engines Exhaust Manifold - Remove
G3304 and G3306 Engines Magneto Drive - Remove and Install
G3520C and G3520E Generator Set Engines Thermostatic Valve - Install
G3500B Engines Air/Fuel Ratio Control - Oxygen Feedback
3116 and 3126 Truck Engines Fuel Transfer Pump - Install
2003/05/01 Compression Brakes Should be Inspected Carefully During Repairs to the Cylinder Head and Valve Mechanism {1119}
3500B Engines Accessory Drive (Lower Left Hand, Reverse Rotation)
3456 Generator Sets Model View Illustrations
2003/05/01 Check OEM Web Sites for Service Letters and Information that may be Related to Product Campaigns {0374}
Cat® Digital Voltage Regulator General Information
BA-921 Bendix Air Compressor Specification
C27 and C32 Generator Sets Jacket Water Heater - Check - Standby Generator Sets (If Equipped)
C15 and C18 Petroleum Generator Sets Battery Charger - Check
G3500B Engines Cooling System
3412C Generator Set Instrument Panel - Inspect