Spark Plugs - Remove and Install
Show/hide table
Required Tool | |||
Tooling | Part Number | Description | Qty |
A | 2P-5481 | Deep Well Socket | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove covers (1) from the spark plugs and adapters.
Show/hide table
Illustration 2 g00991104 - Remove spark plugs (2) with Tooling (A).
Show/hide table
Illustration 1 | g00991102 |
- Install spark plugs (2) with Tooling (A). The spark plug gap should be set at
0.645 ± 0.075 mm (0.0250 ± 0.0030 inch) . Tighten the spark plugs to a torque of35 ± 5 N·m (25 ± 4 lb ft) .Show/hide tableIllustration 4 g00991102 - Install covers (1). Make sure that the cover makes a good connection with the spark plug.
Show/hide table
Illustration 3 | g00991104 |
Caterpillar Information System:
C7 Engines for Combat and Tactical Vehicles Trip Parameters
C7 Engines for Combat and Tactical Vehicles Maintenance Parameters
C7 Engines for Combat and Tactical Vehicles Output Selections
C7 Engines for Combat and Tactical Vehicles Input Selections
C15 On-highway Engine Exhaust Manifold - Remove and Install
3500B and 3500C Marine Propulsion Engines Emergency Stop Switch (Remote)
G3304 and G3306 Engines Rocker Shaft - Assemble
G3304 and G3306 Engines Rocker Shaft - Disassemble
G3304 and G3306 Engines Crankshaft Main Bearings - Install
3054E Industrial Engine Electronic Control Module - Remove and Install
G3304 and G3306 Engines Rocker Shaft and Push Rod - Install
C15 On-highway Engine Water Pump - Install
C7 Engines for Combat and Tactical Vehicles Vehicle Speed Parameters
C7 Engines for Combat and Tactical Vehicles Truck Manufacture Parameters
C15 On-highway Engine Air Compressor - Remove and Install
G3304 and G3306 Engines Spark Plug Adapter - Remove and Install
3618 Engine Cooling System Coolant - Change
3618 Engine Cooling System Coolant Sample (Level 1) - Obtain
Cold Weather Recommendations for On-Highway Diesel Truck Engines Starting Recommendations
3618 Engine Cooling System Supplemental Coolant Additive (SCA) - Test/Add
G3304 and G3306 Engines Aftercooler - Remove
3618 Engine Driven Equipment - Check
3054E Industrial Engine Crankshaft Rear Seal - Remove
2003/05/01 Installation Procedure for a Thermocouple in the Exhaust of a Marine Engine {7498}