0102-02 Boost Pressure signal erratic
产生此代码的情况:
发动机控制模块 (ECM) 检测到以下情况:
- 理想增压压力与实际增压压力之差超过 20 kPa (80 英寸水柱 H2O) 持续八秒钟以上。
- 理想增压压力不为零。
- ECM 至少已通电两秒钟。
系统响应:
ECM 将会记录该事件。
该事件代码保持激活状态 15 分钟后,检查发动机指示灯就将亮起。 卡特彼勒电子技师 (ET) 状态屏上增压压力的旁边会显示"诊断"。
该代码不会影响发动机功率。
测试步骤 1. 进行以下的诊断步骤: 废气旁通电磁阀 - 测试
结果:
- 正常 - 停止
Caterpillar Information System:
C7 and C9 On-Highway Engines 0102-01 Low Boost Pressure (25)
3056E Industrial Engine Fuel Injection Timing - Check
G3520B Engines Detonation Sensors
3126B Engine for Caterpillar Built Machines Injection Actuation Pressure - Test
414E, 416E, 420E and 430E Backhoe Loaders General Information
3054E Industrial Engine Main Bearing Journal - Steel Crankshaft
3054C and C4.4 Industrial Engine and Marine Auxiliary Engine Crankshaft - Steel Crankshaft
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Air Starting Motor - Remove
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Air Starting Motor - Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Air Starting Motor - Disassemble
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Air Starting Motor - Assemble
G3520B Engines Desired Speed Input (4 - 20 mA)
C-10, C-12 and C-15 On-highway Engines 0102-07 Boost Pressure not responding
C-10, C-12 and C-15 On-highway Engines 0173-00 High Exhaust Gas Temperature Derate
C-10, C-12 and C-15 On-highway Engines 0173-11 Very High Exhaust Gas Temperature Derate
3056E Industrial Engine Finding Top Center Position for No. 1 Piston
3034 Engine for Caterpillar Built Machines Increased Engine Oil Temperature - Inspect
G3520B Engines ECM Output Circuit (Fuel Control)
3034 Marine Engine Glow Plugs - Test
3034 Marine Engine Fuel Shutoff Solenoid - Test
G3520B Engines ECM Output Circuit (Starting Motor)
C-10, C-12 and C-15 On-highway Engines Poor Acceleration or Response
C-10, C-12 and C-15 On-highway Engines Low Power/Poor or No Response to Throttle
C-10, C-12 and C-15 On-highway Engines Intermittent Low Power or Power Cutout