Final Drive Oil - Change
Show/hide table
Illustration 1 | g00538194 |
(1) Oil drain plug (2) Oil level plug |
- Position one final drive so that oil drain plug (1) is at the bottom.
- Remove drain plug (1) and level plug (2). Allow the oil to drain into a suitable container.
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on Containing Fluid Spillage.
- Clean the plugs and inspect the O-ring seals. If wear or damage is evident, replace the drain plug, the level plug, and/or the O-ring seals.
- Install drain plug (1) .
- Fill the final drive to the bottom of the opening on level plug (2). See Operation and Maintenance Manual, "Lubricant Viscosities" and Operation and Maintenance Manual, "Refill Capacities".
- Install level plug (2) .
- Perform Step 1 to Step 6 on the other final drive. Use a different container for the oil so that the oil samples from the final drives will be separate.
- Completely remove the oil that has spilled onto surfaces.
- Start the engine and allow the final drives to run through several cycles.
- Stop the engine. Check the oil level.
- Check the drained oil for metal chips or for particles. If there are any chips or particles, consult your dealer.
- Properly dispose of the drained material. Obey local regulations for the disposal of the material.
Caterpillar Information System:
CIPI UNDERCARRIAGE Arrangements: 3Q-6662; 6Z-7861, 7885, 7947, 7957, 7999; 9Q-5044, 5065, 5082, 5090, 5093, 5115, 5118, 5126, 5135, 5141, 5168, 5175, 5206, 5255, 5259, 5268, 5412, 5436, 5464, 5514, 5617, 5618, 5716, 5741, 5742, 5758, 5826, 5831, 5846 Refill Capacities
3512B Engine for SPF343, SPS343, and SPT343 Pumpers Engine Sensor Open/Short Test
CIPI UNDERCARRIAGE Arrangements: 3Q-6662; 6Z-7861, 7885, 7947, 7957, 7999; 9Q-5044, 5065, 5082, 5090, 5093, 5115, 5118, 5126, 5135, 5141, 5168, 5175, 5206, 5255, 5259, 5268, 5412, 5436, 5464, 5514, 5617, 5618, 5716, 5741, 5742, 5758, 5826, 5831, 5846 Final Drive Ring Gear Removal
3500 Generator Set Engines Auxiliary Drive Housing
CIPI UNDERCARRIAGE Arrangements: 3Q-6662; 6Z-7861, 7885, 7947, 7957, 7999; 9Q-5044, 5065, 5082, 5090, 5093, 5115, 5118, 5126, 5135, 5141, 5168, 5175, 5206, 5255, 5259, 5268, 5412, 5436, 5464, 5514, 5617, 5618, 5716, 5741, 5742, 5758, 5826, 5831, 5846 Final Drive Sun Gear Removal
3408E and 3412E Industrial Engines Pressure Sensor (Auxiliary)
3408E and 3412E Industrial Engines CAN Data Link Circuit - Test
2002/02/01 New Lines Groups Are Used On The Continuous Prelube System {1307, 1319}
3408E and 3412E Industrial Engines Air Cleaner
3500 Industrial Engines Fuel Injector
C12 Marine Engine Inlet Manifold Pressure - Test
3408E and 3412E Industrial Engines Muffler
797F Off-Highway Truck Steering System Piston Pump (Steering) - Adjust
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Carrier Roller - Assemble
CIPI UNDERCARRIAGE Arrangements: 9Q-5240, 9Q-5241, 9Q-5242, 9Q-5250, 9Q-5253, 9Q-5265, 9Q-5266, 9Q-5392, 9Q-5393, 9Q-5478, 9Q-5504, 9Q-5621, 9Q-5643, 9Q-5651, 9Q-5709, 9Q-5718, 9Q-5723, 9Q-5724, 9Q-5725, 9Q-5726, 9Q-5731, 9Q-5747, 9Q-5780, 9Q-5792, 9 Final Drive Oil Level - Check
CIPI UNDERCARRIAGE Arrangements: 3Q-6662; 6Z-7861, 7885, 7947, 7957, 7999; 9Q-5044, 5065, 5082, 5090, 5093, 5115, 5118, 5126, 5135, 5141, 5168, 5175, 5206, 5255, 5259, 5268, 5412, 5436, 5464, 5514, 5617, 5618, 5716, 5741, 5742, 5758, 5826, 5831, 5846 Maintenance Interval Schedule
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Carrier Roller - Remove
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Carrier Roller - Disassemble
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Carrier Roller - Install
C-10, C-12, 3176C, and 3196 Bolts for the Front Housing{1151} C-10, C-12, 3176C, and 3196 Bolts for the Front Housing{1151}
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Roller - Remove
3500 Locomotive Engines Engine Design
3500 Locomotive Engines Engine Design
385B Excavator Machine System Specifications Travel Counterbalance Valve