Final Drive Oil Level - Check
Show/hide table
 | |
| Illustration 1 | g00538194 |
(1) Oil drain plug (2) Oil level plug | |
- Position one final drive so that oil drain plug (1) is at the bottom.
- Remove oil level plug (2) .
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on Containing Fluid Spillage.
- Check the oil level. The oil should be near the bottom of the level plug opening.
- Add oil through the level plug opening, if necessary.
Note: Overfilling the final drive will cause the seals on the travel motor to allow hydraulic oil or water to enter the final drive. This may contaminate the final drive.
- Clean oil level plug (2). Inspect the O-ring seal. Replace the O-ring seal if the O-ring seal is worn or damaged.
- Install oil level plug (2) .
- Repeat the procedure for the other final drive.
Caterpillar Information System:
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Carrier Roller - Assemble
797F Off-Highway Truck Steering System Piston Pump (Steering) - Adjust
CIPI UNDERCARRIAGE Arrangements: 166-7047, 177-3011, 177-3553, 177-4279, 200-2995, 200-4060, 204-0808, 212-6225, 213-8653, 215-7227, 218-2237, 231-5143, 3Q-6638, 3Q-6641, 6Z-7749, 6Z-7751, 6Z-7857, 6Z-7890, 6Z-7926, 6Z-7938, 6Z-7992, 9Q-5034, 9Q-5042 Final Drive Oil - Change
CIPI UNDERCARRIAGE Arrangements: 3Q-6662; 6Z-7861, 7885, 7947, 7957, 7999; 9Q-5044, 5065, 5082, 5090, 5093, 5115, 5118, 5126, 5135, 5141, 5168, 5175, 5206, 5255, 5259, 5268, 5412, 5436, 5464, 5514, 5617, 5618, 5716, 5741, 5742, 5758, 5826, 5831, 5846 Refill Capacities
3512B Engine for SPF343, SPS343, and SPT343 Pumpers Engine Sensor Open/Short Test
CIPI UNDERCARRIAGE Arrangements: 3Q-6662; 6Z-7861, 7885, 7947, 7957, 7999; 9Q-5044, 5065, 5082, 5090, 5093, 5115, 5118, 5126, 5135, 5141, 5168, 5175, 5206, 5255, 5259, 5268, 5412, 5436, 5464, 5514, 5617, 5618, 5716, 5741, 5742, 5758, 5826, 5831, 5846 Final Drive Ring Gear Removal
3500 Generator Set Engines Auxiliary Drive Housing
CIPI UNDERCARRIAGE Arrangements: 3Q-6662; 6Z-7861, 7885, 7947, 7957, 7999; 9Q-5044, 5065, 5082, 5090, 5093, 5115, 5118, 5126, 5135, 5141, 5168, 5175, 5206, 5255, 5259, 5268, 5412, 5436, 5464, 5514, 5617, 5618, 5716, 5741, 5742, 5758, 5826, 5831, 5846 Final Drive Sun Gear Removal
3408E and 3412E Industrial Engines Pressure Sensor (Auxiliary)
3408E and 3412E Industrial Engines CAN Data Link Circuit - Test
2002/02/01 New Lines Groups Are Used On The Continuous Prelube System {1307, 1319}
3408E and 3412E Industrial Engines Air Cleaner
CIPI UNDERCARRIAGE Arrangements: 3Q-6662; 6Z-7861, 7885, 7947, 7957, 7999; 9Q-5044, 5065, 5082, 5090, 5093, 5115, 5118, 5126, 5135, 5141, 5168, 5175, 5206, 5255, 5259, 5268, 5412, 5436, 5464, 5514, 5617, 5618, 5716, 5741, 5742, 5758, 5826, 5831, 5846 Maintenance Interval Schedule
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Carrier Roller - Remove
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Carrier Roller - Disassemble
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Carrier Roller - Install
C-10, C-12, 3176C, and 3196 Bolts for the Front Housing{1151} C-10, C-12, 3176C, and 3196 Bolts for the Front Housing{1151}
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Roller - Remove
3500 Locomotive Engines Engine Design
3500 Locomotive Engines Engine Design
385B Excavator Machine System Specifications Travel Counterbalance Valve
3500 Industrial Engines Engine Design
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Track Roller - Disassemble
3408E and 3412E Industrial Engines Flywheel