Fuel Injector Mechanism
Show/hide table
Illustration 1 | g00847684 |
(1) Locknut
- Torque ...
70 ± 15 N·m (50 ± 11 lb ft)
(2) Rocker arm shaft
- Diameter ...
37.084 ± 0.013 mm (1.4600 ± 0.0005 inch) - Bore in bearing for rocker arm shaft ...
37.140 ± 0.015 mm (1.4622 ± 0.0006 inch) - Bore in bearing for rocker arm shaft ...
(3) Guide springs
Guide springs must not be used again. Always install new guide springs.
(4) Lifter
- Diameter ...
29.900 ± 0.010 mm (1.1772 ± 0.0004 inch) - Bore in head for lifter assembly ...
30.000 ± 0.025 mm (1.1811 ± 0.0010 inch) - Bore in head for lifter assembly ...
Caterpillar Information System:
3126E and 3126B Commercial and Truck Engines Exhaust Brake
3054 and 3056 Marine Generator Set Engines Turbocharger - Remove - 3054 Engine
3054 and 3056 Engines 550 Generator Set Control Panel Initial Startup Procedure
3408E and 3412E Engines for Caterpillar Built Machines Gear Group - Inspect
CIPI UNDERCARRIAGE Arrangements: 9Q5221, 9Q5234, 9Q5243, 9Q5245, 9Q5246, 9Q5247, 9Q5385, 9Q5433, 9Q5482, 9Q5622, 9Q5661, 9Q5719, 9Q5720, 9Q5721, 9Q5722, 9Q5830, 9Q5840, 9Q5857, 9Q5874, 9Q5883, 9Q5930 and 9Q5940 Track Adjustment - Adjust
3054 and 3056 Engines 550 Generator Set Control Panel Sender Wiring
2001/12/01 Serviceability Of Metal Particle Detectors {7400}
3126E and 3126B Commercial and Truck Engines Engine Operation
3126B and 3126E On-highway Engines Water Pump - Remove
SPT343 Truck Mounted Pumper Fuel Filter (Engine Coolant Heater) - Replace
2002/05/01 The Connecting Rod On The Air Compressor Is Now Serviceable {1803}
3408E and 3412E Industrial Engines Engine Oil Pressure Sensor - Test
3408E and 3412E Industrial Engines Aftercooler - Test
3054 and 3056 Marine Generator Set Engines Turbocharger - Install - 3054 Engine
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 General Hazard Information
Power Module Switchgear (Low Voltage and Medium Voltage) Switchgear - Check
3054 and 3056 Engines 550 Generator Set Control Panel Troubleshooting
3054 and 3056 Engines 550 Generator Set Control Panel Connector Contact Description
Obtaining Factory Passwords and Software Enabled Attachments{7610, 7620} Obtaining Factory Passwords and Software Enabled Attachments{7610, 7620}
3054 and 3056 Engines 550 Generator Set Control Panel Wiring Diagrams
3054 and 3056 Engines 550 Generator Set Control Panel Control Module - Replace
325D and 329D Excavators Hydraulic System Swing Motor
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Adjustment - Inspect
SPT343 Truck Mounted Pumper Plate Locations and Film Locations