3116 Truck Engines Caterpillar


Engine Oil Pressure

Usage:

3116 2BK
Minimum engine oil pressure ... 250 kPa (36 psi)

Minimum engine oil pressure at low idle (750 to 850 rpm) is the following value. ... 100 kPa (15 psi)

Maximum engine oil pressure at operating temperature and operating under full load condition is the following value. ... 600 kPa (87 psi)

Caterpillar Information System:

2002/05/01 The Torque Has Been Increased For The Bolts That Fasten The Stub Shafts To The Engine Cylinder Block {1237}
3116 Truck Engines Turbocharger
G3408 and G3412 Engines Plate Locations and Film Locations
2001/10/01 The New Special Instruction, REHS1147, "Operating Instructions for Program Storage Device" Is Available {0709}
3512B Marine Auxiliary Engine Cold Weather Starting
3512B Marine Auxiliary Engine Programmable System Parameters
2001/11/01 Corrections to Disassembly and Assembly , "Inlet and Exhaust Valve Guides - Remove and Install" {1104}
K65-12B Voltage Regulator Service Tools
3116 Truck Engines Fuel Heater and Water Separator
3054 and 3056 Engines 520 Generator Set Control Panel Automatic Operation
G3606 and G3608 Engines Gas Shutoff Valve - Inspect
3116 Truck Engines Fuel Lines
2001/11/01 Corrections to Disassembly and Assembly , "Inlet and Exhaust Valve Guides - Remove and Install" {1104}
G3300 Engines Cooling System Supplemental Coolant Additive (SCA) - Test/Add
SCT673 Truck Mounted PumperPOD Plate Locations and Film Locations
3054 and 3056 Engines 520 Generator Set Control Panel Manual Operation
2002/01/21 A New Quick Coupler is Required to Extend the Service Life of Dual Purpose Valves {6129, 7542}
3054 and 3056 Engines 520 Generator Set Control Panel Alarm Operation
3116 Truck Engine Engine Design
2001/11/12 Corrections to Disassembly and Assembly , "Inlet and Exhaust Valve Guides - Remove and Install" {1104}
3054 and 3056 Marine Generator Sets Before Starting Engine
3116 Truck Engine General Information
3116 Truck Engine Fuel System
3116 Truck Engine Air Inlet and Exhaust System
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.