Speed Sensor - Adjust
Passive Speed Sensor
The engine speed sensor sends the engine speed signal to the engine speed switch and to the transmitter.
Show/hide table
Illustration 1 | g00562936 |
- Adjust the sensor's clearance from the flywheel.
- The engine is secured. Install the sensor until the sensor contacts the flywheel.
- Back off the sensor (2.5 ± 0.1 turns).
- Measure clearance between the flywheel and the electronic sensor (1). The clearance should be 1.55 mm (0.061 inch) to 1.83 mm (0.072 inch).
- Tighten locknut (2) to a torque of 45 ± 7 N·m (33 ± 5 lb ft).
Caterpillar Information System:
3608 Engine Marine Monitoring System Performance Tests
3608 Engine Marine Monitoring System System Tests
3608 Engine Marine Monitoring System Overspeed Verification Test
3608 Engine Marine Monitoring System Resistance Temperature Detector
3608 Engine Marine Monitoring System Thermocouple Sensor
3608 Engine Marine Monitoring System Transducer
3608 Engine Marine Monitoring System Contactor
3608 Engine Marine Monitoring System Digital Input Card
3608 Engine Marine Monitoring System Low Battery Power
3608 Engine Marine Monitoring System Central Processing Unit Fatal Error
3608 Engine Marine Monitoring System Central Processing Unit Cannot Find Active Nodes
3608 Engine Marine Monitoring System Central Processing Unit Fault
3608 Engine Marine Monitoring System Battery - Replace
3126E Truck Engines Exhaust Brake
3608 Engine Marine Monitoring System Memory Module - Replace
G3406 Engine Grounding Practices
3608 Engine Marine Monitoring System Central Processing Unit - Replace
3608 Engine Marine Monitoring System Connector Contact Description
G3406 Engine Starting System
G3408C and G3412C Engines Connecting Rod Bearings - Remove and Install
C15 Petroleum Generator Set Engines Electronic Unit Injector - Adjust
G3500 Engines Manifold Air Pressure Sensor
HDB Series and M1 Series Heavy Duty Brushless Alternators Alternator - Disassemble - M1 Series Alternator (35 Amp)
3512B Marine Auxiliary Engine Engine Monitoring System