Engine Oil Cooler - Remove
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove engine oil filter (3) from oil cooler (2) .
Show/hide table
Illustration 1 | g00810331 |
- Remove coolant hoses (1) from engine oil cooler (2) .
- Remove engine oil cooler adapter bolt (4) from the engine and remove engine oil cooler (2) .
Show/hide table
Illustration 2 | g00810338 |
Caterpillar Information System:
3500B and 3500 Marine Propulsion Engines with EUI Option Centrifugal Oil Filter - Inspect
3034 Marine Engine Inlet Manifold - Remove
3512B Marine Auxiliary Engine MID 047 - CID 0190 - FMI 07 Primary Speed Sensor misinstalled
3034 Marine Engine - Installation Guide Fuel System
3126B Marine Engines Glossary
G3600 Engines Engine Design
3512B Marine Auxiliary Engine MID 047 - CID 0342 - FMI 07 Secondary Speed Sensor misinstalled
G3304 and G3306 Engines Basic Engine
3512B Marine Auxiliary Engine MID 047 - CID 0248 - FMI 09 CAT Data Link not communicating
37-MT, 41-MT, and 42-MT Series Starting Motors Pinion Clearance - Adjust
Product Link 151/201 Wiring Harness (Open Circuit) - Test
3034 Marine Engine Exhaust Manifold - Remove and Install
3034 Marine Engine Engine Oil Cooler - Install
3034 Marine Engine Marine Transmission Oil Cooler Core - Remove and Install
G3304 and G3306 Engines Restriction of Air Inlet and Exhaust
37-MT, 41-MT, and 42-MT Series Starting Motors Starting Motor - Assemble - 37-MT and 41-MT
G3304 and G3306 Engines Measuring Inlet Manifold Temperature
3034 Marine Engine Auxiliary Water Pump - Remove
3034 Marine Engine Auxiliary Water Pump - Install
3034 Marine Engine Auxiliary Water Pump - Disassemble
G3304 and G3306 Engines Measuring Inlet Manifold Pressure
37-MT, 41-MT, and 42-MT Series Starting Motors Starting Motor - Disassemble - 42-MT
G3500 Engines Air Inlet and Exhaust System Components
3034 Marine Engine Auxiliary Water Pump - Assemble