Engine Design
Show/hide table
图 1 | g00472128 |
柴油机设计 (A) 进气 (B) 气体进入阀 (C) 排气 |
气缸数和气缸布置 ... 50° V 16
每气缸气门数
- 进气门 ... 2
- 排气门 ... 2
- 气体进入阀 ... 1
排量 ... 339.3 L (20700 cu in)
缸径 ... 300 mm (11.8 in)
冲程 ... 300 mm (11.8 in)
压缩比 ... 9:1
压缩比 ... 10.5:1
燃烧方式 ... 火花点火
点火顺序
- 标准转动 CCW ... 1-2-5-6-3-4-9-10-15-16-11-12-13-14-7-8
气门间隙
- 进气门 ... 0.50 mm (.020 in)
- 排气门 ... 1.27 mm (.050 in)
- 气体进入阀 ... 0.64 mm (.025 in)
从飞轮端观看曲轴时,曲轴沿以下方向旋转。 ... 逆时针
注: 发动机的前端是与发动机飞轮端相对的发动机的另一端。 发动机的左、右侧是从发动机飞轮端来判断的。 第 1 缸是最右前端的气缸。
Caterpillar Information System:
3512B Marine Auxiliary Engine MID 047 - CID 0342 - FMI 07 Secondary Speed Sensor misinstalled
G3304 and G3306 Engines Basic Engine
3512B Marine Auxiliary Engine MID 047 - CID 0248 - FMI 09 CAT Data Link not communicating
37-MT, 41-MT, and 42-MT Series Starting Motors Pinion Clearance - Adjust
Product Link 151/201 Wiring Harness (Open Circuit) - Test
3034 Marine Engine Exhaust Manifold - Remove and Install
3126B Marine Engines System Overview
3034 Marine Engine Heat Exchanger - Install
3512B Marine Auxiliary Engine Analog Sensor - Calibrate
3456 Generator Sets Bearing - Lubricate
3512B Marine Auxiliary Engine Starting Motor System
3456 Generator Sets Generator Operation
3126B Marine Engines Glossary
3034 Marine Engine - Installation Guide Fuel System
3512B Marine Auxiliary Engine MID 047 - CID 0190 - FMI 07 Primary Speed Sensor misinstalled
3034 Marine Engine Inlet Manifold - Remove
3500B and 3500 Marine Propulsion Engines with EUI Option Centrifugal Oil Filter - Inspect
3034 Marine Engine Engine Oil Cooler - Remove
3034 Marine Engine Engine Oil Cooler - Install
3034 Marine Engine Marine Transmission Oil Cooler Core - Remove and Install
G3304 and G3306 Engines Restriction of Air Inlet and Exhaust
37-MT, 41-MT, and 42-MT Series Starting Motors Starting Motor - Assemble - 37-MT and 41-MT
G3304 and G3306 Engines Measuring Inlet Manifold Temperature
3034 Marine Engine Auxiliary Water Pump - Remove