Engine Oil Pump - Assemble
组装步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
B     | 1P-0510     | 起子总成     | 1     |
Show/hide table
图 1 | g01038181 |
- 使用工具 (B) 将轴承 (8) 安装到发动机机油泵中。 轴承接头应距两个轴承孔中心线 30 ± 15 度。 安装轴承时,让轴承与发动机机油泵的外部齐平。
- 用洁净的发动机机油润滑轴承。
- 使用清洁的发动机机油润滑惰轮和主动齿轮 (3) 。 安装惰轮和主动齿轮 (3) 。
Show/hide table
图 2 | g01028300 |
- 安装盖 (4) 。
注: 在组装后发动机机油泵必须能转动自如。 用手转动发动机机油泵。 如果发动机机油泵不能转动自如,重新安置盖 (4) 。
- 安装旁通阀 (5) 、弹簧 (6) 和挡圈 (7) 。
- 安装主动齿轮 (1) 。 安装螺栓 (9) 。 拧紧螺栓至扭矩为 55 ± 10 N·m (41 ± 7 lb ft)。
Show/hide table
图 3 | g01038184 |
End By: 安装发动机机油泵。 请参阅 拆解和组装, "发动机机油泵 - 安装"。
Caterpillar Information System:
3406E and C15 Marine Engines Engine Oil Pump - Disassemble
3406E Marine Engine Engine Oil Pump - Remove
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Signal Listing
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Reference Material
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Resistance Temperature Detector
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Overspeed Verification Test
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Service Tools
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System General Information
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Related Components
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Resistance Temperature Detectors
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Display
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Remote Operation
Unpacking Instructions for the Uninterruptible Power Supply{4480} Unpacking Instructions for the Uninterruptible Power Supply{4480}
C-9 Industrial Engine Jacket Water Heater - Remove and Install
C15 and C18 Petroleum Generator Sets Fire Prevention and Explosion Prevention
3306B-XQ200 Rental Generator Set Engine Enclosure Identification
3306B-XQ200 Rental Generator Set Engine Trailer Identification
3306B-XQ200 Rental Generator Set Engine Engine Lifting
Unpacking Instructions for the Uninterruptible Power Supply{4480} Unpacking Instructions for the Uninterruptible Power Supply{4480}
3508, 3512, and 3516 Generator Sets Electronic Modular Control Panel II+ (EMCP II+)
3306B-XQ200 Rental Generator Set Engine Before Starting Engine
3306B-XQ200 Rental Generator Set Engine Emergency Stopping
3406E Marine Engine Heat Exchanger - Disassemble
3306B-XQ200 Rental Generator Set Engine Setup