NOTICE |
---|
Do not spray or splash water into the generator air inlet or exhaust openings. Ensure that the openings are covered in order to prevent water from entering the electrical windings and bearings. |
The interior of the enclosure package and the exterior of the enclosure package should be kept clean. Wash the interior of the enclosure package and the exterior of the enclosure package with soap and water.
Ensure that the air discharge for the exhaust duct is clear. Clean debris, twigs, and leaves away from the enclosure package, as needed.
Lubricate the hinges on the door, as needed. Use Caterpillar Multipurpose Lithium Complex Grease (MPGL). If Caterpillar Multipurpose Lithium Complex Grease (MPGL) is not available, use a similar multipurpose grease.
Note: Only chrome hinges require lubrication. Powder black door hinges do not require lubrication.
Illustration 1 | g01190640 |
Screws for the door hinge |
Adjust the door hinges, as required. Visually check the alignment of the door. Use the following steps to adjust the alignment of the door.
- Loosen the screws on the door hinge.
- Reposition the door so that the door is square within the door frame.
- Tighten the screws on the door hinge.
Check the door seal. Adjust the closure fit of the door against the gasket seal. Bend the catch for the door handle inward. This will tighten the door against the gasket seal. Bend the catch for the door handle outward. This will loosen the door against the gasket seal.
The literature pouch is located near the operator console. Ensure that the literature pouch contains a copy of the following literature:
- this manual
- the Generator Operation and Maintenance Manual