Air Inlet Heater - Remove and Install
Removal Procedure
- Disconnect harness assembly (1) .
Show/hide table
Illustration 1 | g01025934 |
Typical example |
- Disconnect cable assembly (4) .
- Position the cover for air inlet heater (2) out of the way.
- Remove air inlet heater (3) .
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 4C-9500     | Quick Cure Primer     | 1     |
B     | 1U-8846     | Gasket Sealant     | 1     |
- Clean the joint face on air inlet heater (3) with solvent. Apply Tooling (A) on the joint face. Allow the primer to air dry for a minimum of three to five minutes.
Show/hide table
Illustration 2 | g01025934 |
Typical example |
- Apply Tooling (B) to the joint face of air inlet heater (3) and on the joint face of air inlet elbow (2). Air inlet heater (3) and the cover for air inlet heater (2) must be installed within ten minutes of application of the sealant.
- Position air inlet heater (3) and the cover for air inlet heater (2) on the air inlet cover.
- Connect cable assembly (4) to the solenoid of the air inlet heater. Tighten the nut to a torque of 6 ± 0.5 N·m (53 ± 4 lb in).
- Connect harness assembly (1) .
Caterpillar Information System:
3126B Industrial Engine Fuel Filter Base - Remove and Install
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Emergency Stop Switch
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets ECM/Personality Module
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Digital Sensor Supply
C-15 and C-16 Industrial Engines Engine Oil Pan
C-15 and C-16 Industrial Engines Gauges and Indicators
3054 and 3056 Industrial and Generator Set Engines Fuel System Pressure - Test
3500B Engines Turbocharger
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Cat Data Link
3054, 3054B and 3056 Marine Engines Fuel System - Prime
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Analog Sensor Supply
Cross-Reference for Electrical Connectors {7553} Cross-Reference for Electrical Connectors {7553}
3126B Industrial Engine Engine Oil Pan - Remove and Install
3126B Industrial Engine Belt Tightener - Install
3126B Industrial Engine Belt Tightener - Remove
3126B Industrial Engine Vibration Damper and Pulley - Remove and Install
C-10 and C-12 Industrial Engines Air Inlet and Exhaust System
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Engine Sensor Open/Short Test
C-15 and C-16 Industrial Engines Water Lines
C-10 and C-12 Industrial Engines Lubrication System
3126B Industrial Engine Water Pump - Assemble
3054, 3054B and 3056 Marine Engines Engine Valve Lash - Inspect/Adjust
C32 Petroleum Engines Diagnostic Flash Code Retrieval
3054 Engine Cylinder Head - Inspect