Fuel Transfer Pump - Install
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Inspect the condition of the gasket. Replace the gasket, if necessary.
Show/hide table
 | |
| Illustration 1 | g00759022 |
- Ensure that the rocker arm for the fuel transfer pump is not under pressure.
- Install the gasket and fuel transfer pump (2) onto the cylinder block. If it is difficult to install the fuel transfer pump, rotate the crankshaft.
- Install four bolts (4). Tighten the bolts to a torque of 22 N·m (16 lb ft).
- Connect two fuel lines (1) to the fuel transfer pump.
- Loosen the vent screw on the top of the fuel filter and operate priming lever (3) on the fuel transfer pump in order to remove the air from the fuel system. When only fuel comes out of the vent screw, tighten the vent screw.
- Start the engine and check the fuel system for fuel leaks and for air leaks.
Caterpillar Information System:
3054 and 3056 Industrial and Generator Set Engines Vibration Damper - Check
2001/04/01 Remanufactured Governor Actuator Assemblies Are Available {1716}
3054, 3054B and 3056 Marine Engines Fuel System
3054 Engine Exhaust Temperature - Test
320D and 323D Excavators Machine System Specifications Bucket Cylinder Lines
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Coolant Temperature Is Too High
3054, 3054B and 3056 Marine Engines General Information
3054, 3054B and 3056 Marine Engines Engine Design
2000/12/01 A New Integral Seal Is Being Used In The Water Lines Groups {1380}
3054, 3054B and 3056 Marine Engines Fuel Shutoff Solenoid - Remove and Install - Bosch and Delphi Fuel Injection Pumps
3126B Industrial Engine Fuel Filter and Water Separator
2000/12/01 Engine Troubleshooting Guides Are Available For Gas Engines {1000}
3054 and 3056 Marine Generator Set Engines Fuel Transfer Pump - Remove
3054 Engine Belt Tension Chart
C-10 and C-15 Petroleum Engines Intermittent Low Power or Power Cutout
3054 Engine Belt Tension Chart
2000/12/01 A New Hose Assembly Is Used In The Water Lines Group {1380}
C-15 and C-16 Industrial Engines Engine Design
3176C and 3196 Engines for Caterpillar Built Machines E015 High Engine Coolant Temperature Derate
797 Off-Highway Truck Power Train Pressure Sensor (Differential Oil)
797 Off-Highway Truck Power Train Bypass Switch (Differential Oil Filter)
797 Off-Highway Truck Power Train Pressure Switch (Final Drive Oil)
2001/01/01 A New Screen In The TMI System Provides The Status Of Emission Certification Of Engines {1000}
2001/01/08 A New Screen In The TMI System Provides The Status Of Emission Certification Of Engines {1000}