3054 and 3056 Industrial and Generator Set Engines Caterpillar

The vibration damper is installed on the front of the crankshaft. The vibration damper is balanced in order to help remove torsional vibration in the engine.

Replace the vibration damper if any of the following conditions exist:

• The rubber insert between the hub and the outer ring is split.

• The rubber insert is damaged by oil or solvents.

• There is movement of the pulley or the outer ring on the hub.

• There is a large amount of gear train wear that is not caused by lack of oil.

• Analysis of the engine oil has revealed that the front main bearing is badly worn.

• The engine has had a failure because of a broken crankshaft.

Check the areas around the holes in the vibration for the bolts for cracks or for wear.

Table 1

Required Tools
Part number	Part Name		Qty
8T-5096	Dial Indicator Group		1

Use the following steps in order to check the alignment and the runout of the vibration damper:

1. Remove any debris from the front face of the vibration damper. Remove any debris from the circumference of the vibration damper.

2. Use a suitable lever in order to move the vibration damper forward. This will eliminate the end play of the crankshaft. Do not use excessive force to move the vibration damper away from the engine.

3. Mount the dial indicator group on the front cover. Use the dial indicator to measure the outer face of the vibration damper. Set the dial indicator to read 0.00 mm (0.00 inch).

4. Rotate the crankshaft at intervals of 90 degrees and read the dial indicator.

5. The difference between the lower measurements and the higher measurements that are read on the dial indicator at all four points must not be more than 0.18 mm (0.007 inch).

   If the reading on the dial indicator is more than 0.18 mm (0.007 inch), inspect the pulley and the vibration damper for damage. If the pulley or the vibration damper are damaged, use new parts for replacement.

6. Move the dial indicator so that the dial indicator will measure the circumference of the vibration damper. Set the dial indicator to read 0.00 mm (0.00 inch).

7. Slowly rotate the crankshaft in order to measure the runout of the circumference of the vibration damper. Use the highest reading and the lowest reading on the dial indicator. The maximum and the minimum readings on the dial indicator should not vary more than 0.12 mm (0.005 inch).

   If the reading on the dial indicator is more than 0.12 mm (0.005 inch), inspect the pulley and the vibration damper for damage. If the pulley or the vibration damper are damaged, use new parts for replacement.