Air Inlet Elbow - Remove and Install
拆卸步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 松开软管卡箍 (2) 后将软管 (1) 从进气弯头 (3) 上拆下。
Show/hide table
 | |
| 图 1 | g00728048 |
- 将插头 (5) 从空气温度传感器上断开。
Show/hide table
 | |
| 图 2 | g00728030 |
- 拆下八条螺栓 (4) 。 拆下进气弯头 (3) 。
安装步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 利用溶剂清洗进气弯头和进气盖的接合面。 将 4C-9500 快速固化底漆 涂抹到接合面上。 允许粘合涂层进行至少 3 到 5 分钟的风干。
- 将 1U-8846 密封胶 涂抹到进气弯头和进气盖的接合面上。 进气弯头的安装必须在涂抹密封胶后的 10 分钟内完成。
- 将进气弯头 (3) 定位到进气盖上。
Show/hide table
| | |
| 图 3 | g00728030 |
- 安装八条螺栓 (4) 。
- 将插头 (5) 连接到空气温度传感器上。
- 将软管 (1) 安装到进气弯头 (3) 上。 拧紧软管卡箍 (2) 。
Show/hide table
| | |
| 图 4 | g00728048 |
Caterpillar Information System:
3500 Generator Set Engines Indicators for Engine Oil Pressure
SR4 HV and SR4B HV Generators General Hazard Information
Machine Security System Protected Functions
Generator Set Control Panel for Switchgear Conversion Numeric Readout Mode
Machine Security System Operation of Status Indicator
Machine Security System Service Tools
3500 Engines For Caterpillar Built Power Modules Valve Lash and Valve Bridge Adjustment
Machine Security System Glossary of Terms
3126B Engine for Caterpillar Built Machines Unit Injector Hydraulic Pump
Installation of the Cat Digital Ignition System for G3406 Engines{1550} Installation of the Cat Digital Ignition System for G3406 Engines{1550}
EMCPII+ for Gas Engines Indicators of Alarm Module or Remote Annunciator Are Constantly Flashing
3500B Marine Engines Synchronizing Switch Not Functioning Properly
Machine Security System Key - Program
Machine Security System Diagnostic Operation
Machine Security System Events
Machine Security System Service Operation Using Machine Security System
Machine Security System Key Information
Machine Security System Service Operation Using Service Tool
3508, 3512, and 3516 Generator Sets Overhaul (Major)
Generator Set Control Panel for Switchgear Conversion Electrical Components And Connector Locations
3500 Engines For Caterpillar Built Power Modules Visual Inspection
Machine Security System Using Caterpillar Electronic Technician to Determine Diagnostic Codes
Machine Security System Electronic Control Module (ECM)
3508, 3512, and 3516 Generator Sets Overhaul (Top End)