Generator Oil Filter - Change
Replace the oil filter for the generator when either of the following conditions occur:
- The indicator for the filter is in the red zone.
- The oil for the generator is changed.
- Remove two bolts and washers (1).
- Remove filter case (2) and the element. Dispose of the used element.
- Clean the inside of the filter case with clean, nonflammable solvent.
- Inspect a new element for good condition. Install the element into the filter case.
- Place the filter case into position. Secure the filter with two bolts and washers (1).
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| |
| Illustration 1 | g00716411 |
Caterpillar Information System:
Programmable Relay Control Module (PRCM) Display Codes
C175-16 Locomotive Engine Checking Engine Cylinders with an Electronic Service Tool
3608 Engine Generator Oil - Change
3524B Engines for 797 and 797B Off-Highway Trucks Fuel System Inspection
325D and 329D Excavators and 325D Material Handler Machine System Specifications Shuttle Valve (Pilot Lines)
3608 Engine Engine Oil Sample - Obtain
Programmable Relay Control Module (PRCM) Block Diagram
3608 Engine Air Starting Motor Lines Screen - Clean
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application Component Installation
3500B Engines for Caterpillar Built Power Modules Turbocharger
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil Level Gauge - Calibrate - 3406E, C-15 and C-16 Truck Engines Only
SPT343 Truck Mounted Pumper Belts - Inspect/Adjust/Replace
3608 Engine Generator Oil Level - Check
3408E and 3412E Engines for Caterpillar Built Machines Pinion Clearance - Adjust
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>7E-0097</B> Generator through <B>7E-9695</B> Generator
3608 Engine Air Prelube Pump Lubricator Bowl - Clean
3500B and 3500B High Displacement Generator Set Engines Measuring Inlet Manifold Pressure
2000/06/01 Special Instruction, REHS0589-01, "Emergency Stop Circuit Improvement for the Electronic Instrument Panel to Control Engine Restart" is Available {7451}
3524B Engines for 797 and 797B Off-Highway Trucks Crankcase Pressure
3508B Industrial Engine with an ADEM 2 Electronic Control Module Emergency Stop Switch (Remote)
SPT342 Truck Mounted Pumper Gauges and Indicators
3406E, C-10 and C-12 Truck Engines Severe Service Application - Check
Programmable Relay Control Module (PRCM) Electrical Connector - Inspect
3500 Engines For Caterpillar Built Power Modules Engine Oil Pressure is Low