Removal Procedure
| Required Tooling | |||
| Tool | Part Number | Part Description | Qty |
| A | 138-7575 | Link Bracket | 2 |
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
- Drain the hydraulic tank into a suitable container for storage or for disposal. Refer to Operation and Maintenance, "Hydraulic System Oil - Change".
- Attach a suitable lifting device to side door (1). The weight of side door (1) is approximately 34 kg (75 lb).
 | |
| Illustration 1 | g01500253 |
- Remove bolts (2) .
 | |
| Illustration 2 | g01500274 |
- Remove bolts (3) and side door (1) .
 | |
| Illustration 3 | g01500293 |
- Remove bottom guard (4) .
 | |
| Illustration 4 | g01500493 |
- Disconnect harness assembly (5) .
 | |
| Illustration 5 | g01500533 |
- Cut all necessary cable straps (6) .
 | |
| Illustration 6 | g01501735 |
- Remove bolts (8) and position filter assembly (7) to one side.
 | |
| Illustration 7 | g01501736 |
- Cut all necessary cable straps (9) .
 | |
| Illustration 8 | g01501749 |
- Remove screws (10) in order to disconnect harness assembly (5). Disconnect clip (11) and position harness assembly (5) to one side.
 | |
| Illustration 9 | g01501750 |
- Disconnect clip (12). Disconnect all necessary hose assemblies (13) .
 | |
| Illustration 10 | g01501762 |
- Disconnect hose (14) .
 | |
| Illustration 11 | g01501799 |
- Attach Tooling (A) and a suitable lifting device to hydraulic tank (15). The weight of hydraulic tank (15) is approximately 65 kg (143 lb).
 | |
| Illustration 12 | g01501802 |
- Remove bolts (16) and the spacers. Repeat for the other side.
 | |
| Illustration 13 | g01501804 |
- Remove hydraulic tank (15) .