Make sure that all of the messages are legible. Clean the messages or replace the messages if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. Loose adhesive will allow the messages to fall.
Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on the replacement part. Any Caterpillar dealer can provide new messages.
 | |
| Illustration 1 | g01500879 |
Additional messages (if equipped) | |
 | |
| Illustration 2 | g01500885 |
Additional messages (if equipped) | |
 | |
| Illustration 3 | g01500880 |
Clean the Windows (1)
This message is located on the upper window in the cab.
 | |
| Illustration 4 | g01069071 |
See Operation and maintenance Manual, "Windows - Clean" for instructions on cleaning windows.
Data Privacy (2)
This message is located on the window on the right side of the cab.
 | |
| Illustration 5 | g01418953 |
The Product Link System is a satellite communication device that transmits information regarding the machine back to Caterpillar and Caterpillar dealers and customers. All logged events and diagnostic codes that are available to the Caterpillar Electronic Technician (ET) on the CAT data link can be sent to the satellite. Information can also be sent to the Product Link System. The information is used to improve Caterpillar products and Caterpillar services.
Refer to Operation and Maintenance Manual, "Product Link" for more information.
Alternate Exit (3)
If equipped, this message is located on the rear window of the cab.
 | |
| Illustration 6 | g01069768 |
The rear window serves as an alternate exit.
A hammer is mounted in the cab near the rear window. Strike the rear window with the hammer in order to break the glass. Climb through the opening of the rear window in order to exit the cab.
Refer to Operation and maintenance Manual, "Alternate Exit" for more information.
Machine Security System (4)
This message is located on the window on the right side of the cab.
 | |
| Illustration 7 | g01396277 |
This machine may be equipped with a security system. Read the Operation and Maintenance Manual before you operate the machine.
Refer to Operation and Maintenance Manual, "Machine Security System".
Alternate Exit Lock/Unlock (5)
If equipped, this message is located on the rear window in the cab.
 | |
| Illustration 8 | g01353053 |
| NOTICE |
|---|
Unlock alternate exit window during machine operations. |
Move the lever to the left to the UNLOCK position. Move the lever to the right to the LOCK position. Exit through rear window.
For more information, refer to Operation and Maintenance Manual, "Alternate Exit".
Counterweight (6)
This message is located underneath the cover on the counterweight.
 | |
| Illustration 9 | g01435946 |
Do not tighten the counterweight mounting bolts without checking the retainer pin for the proper position.
Refer to Operation and Maintenance Manual, "Counterweight Removal and Installation" for more information.
Radial Air Cleaner (7)
This message is located on the cover of the air cleaner.
 | |
| Illustration 10 | g01134494 |
In order to avoid engine damage, replace old filters with radial seal air filters.
The location and design of the gasket for the radial seal air filter is critical to the proper operation of the air cleaner element. Use only Caterpillar replacements.
Refer to Operation and Maintenance Manual, "Engine Air Filter Primary Element - Clean/Replace".