Cylinder Head - Inspect
Show/hide table
| 所需工具 | ||
| 零件号 | 零件名称 | 数量 |
| 8S - 6691 | 缸盖修理支架 | 1 |
| 1U - 7234 | 塞尺 | 1 |
- 以如图 1 中所示的相反顺序卸下缸盖螺栓。
Show/hide table
 | |
| 图 1 | g01355662 |
螺栓拧紧顺序 | |
- 彻底清洁缸盖。 确保缸盖与缸体的接触面清洁、光滑和平整。
- 检查缸盖底面有无点蚀、腐蚀和裂纹。 检查阀座镶圈及喷油器喷嘴孔周围的区域。
- 将缸盖 (1) 置于 8S-6691 缸盖支架 (2) 上。
Show/hide table
 | |
| 图 2 | g00876690 |
(1) 缸盖 (2) 缸盖修理支架 | |
- 使用直尺 (1) 和塞尺 (2) 测量缸盖的平度。
Show/hide table
 | |
| 图 3 | g01367177 |
Caterpillar Information System:
C4.2 and C6.4 Engines for Caterpillar Built Machines Connecting Rod - Inspect
C4.2 and C6.4 Engines for Caterpillar Built Machines Engine Oil Pump - Inspect
C4.2 and C6.4 Engines for Caterpillar Built Machines Engine Oil Pressure - Test
M313D, M315D, M316D, M318D and M322D Excavators and M318D MH and M322D MH Material Handlers Lifting Capacities - M316D Excavator with a Offset Boom (Heavy Lift Option)
2007/04/16 New Software for the Auxiliary Hydraulic Circuits Is Available {7610, 7620}
2007/06/18 A New Idler Pulley Is Available for the Engine Pulley Group {1361}
Filtration Procedure for Oil in the Motor Grader Tandem Drive {0680, 0738, 0768, 4062, 4064} Filtration Procedure for Oil in the Motor Grader Tandem Drive {0680, 0738, 0768, 4062, 4064}
C4.2 and C6.4 Engines for Caterpillar Built Machines Compression - Test
C4.2 and C6.4 Engines for Caterpillar Built Machines Air Inlet and Exhaust System - Inspect
C4.2 and C6.4 Engines for Caterpillar Built Machines Fuel System - Prime
321D LCR Excavator Lifting Capacities
C4.2 and C6.4 Engines for Caterpillar Built Machines Fuel Injection Timing - Check
C4.2 and C6.4 Engines for Caterpillar Built Machines Piston Height - Inspect
C4.2 and C6.4 Engines for Caterpillar Built Machines Flywheel - Inspect
C4.2 and C6.4 Engines for Caterpillar Built Machines Flywheel Housing - Inspect
M313D, M315D, M316D, M318D and M322D Excavators and M318D MH and M322D MH Material Handlers Lifting Capacities - M318D MH Excavator
M313D, M315D, M316D, M318D and M322D Excavators and M318D MH and M322D MH Material Handlers Lifting Capacities - M322D MH Excavator
2007/04/23 Shut Off Valves Lock the Thumb of Backhoe Loaders {1329, 6547}
R2900G Load Haul Dump Bucket Control Group Safety Pins
C15 and C18 Petrolem Generator Set Engines General Information
385B and 5090B Excavators Excavator Systems Swing Gear and Bearing - Remove
584 and 584HD Forwarders Visibility Information
2007/05/14 New Screws for the Door Hinge on the Cab {7308}
330D and 336D Excavators and 330D Material Handlers Machine System Specifications Boom Lines