Make sure that all of the safety messages are legible. Clean the safety messages or replace the safety messages if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the safety messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the safety messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety message. Loose adhesive will allow the safety message to fall.
Replace any safety message that is damaged, or missing. If a safety message is attached to a part that is replaced, install a safety message on the replacement part. Any Caterpillar dealer can provide new safety messages.
Illustration 1 | g01251047 |
Operation (1)
This warning is located on the top of the hammer tool and on the front of the power pack.
g01125097 |
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility. |
Noise Level (2)
Illustration 2 | g01251050 |
This information is located on the side of the power pack.
g01251053 |
This information is located on the side of the hammer tool.
Hot Surface (3)
This warning is located on the side of the hammer.
g01194598 |
The outside of the breaker can be more than 30 °C (54 °F) warmer than the air temperature which can cause personal injury or death. Always wear gloves and the appropriate protective clothing. |
Personal Protective Equipment (4)
This information is located on the top of the hammer tool.
g01194602 |
Eye protection, ear protection, and foot protection is mandatory for operation of this work tool.