Quick Coupler - Lubricate
It is important to follow the lubrication instructions for the Hydraulic Pin Grabber Quick Coupler. Otherwise, some of the grease fittings may be overlooked.
- Uncouple the work tool. Refer to Operation and Maintenance Manual, "Operating Technique Information".
- Retract the bucket cylinder.
- Grease the fitting (1) on the hook.
Show/hide table
Illustration 1 | g01188253 |
- Lock the hook by moving the switch to the LOCK position.
- Extend the bucket cylinder in order to position the coupler so the cylinder fittings are accessible.
- Grease the cylinder fittings on the piston end (2) and on the rod end (3) .
Show/hide table
Illustration 2 | g01188277 |
Caterpillar Information System:
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Muffler - Remove and Install
390D Excavator Machine Systems Joystick Control - Remove and Install - Right Hand
390D Excavator Machine Systems Joystick Control - Remove and Install - Left Hand
325C Excavator Engine Supplement Air Inlet Cover - Remove and Install
325C Excavator Engine Supplement Bottom Guard (Engine) - Remove and Install
303C CR, 303.5C CR, 304C CR and 305C CR Mini Hydraulic Excavators Engine Oil and Filter - Change
303C CR, 303.5C CR, 304C CR and 305C CR Mini Hydraulic Excavators Engine Oil Sample - Obtain
Pin Grabber Quick Hitch Quick Coupler - Inspect
303C CR, 303.5C CR, 304C CR and 305C CR Mini Hydraulic Excavators Engine Oil Level - Check
303C CR, 303.5C CR, 304C CR and 305C CR Mini Hydraulic Excavators Engine Air Filter Service Indicator - Inspect
303C CR, 303.5C CR, 304C CR and 305C CR Mini Hydraulic Excavators Engine Air Filter Primary Element - Clean/Replace
390D Excavator Machine Systems Pressure Reducing Valve - Assemble
Pin Grabber Quick Hitch Quick Coupler Installation and Removal
345C MHPU Mobile Hydraulic Power Unit Machine Systems Main Control Valve - Disassemble
345C MHPU Mobile Hydraulic Power Unit Machine Systems Main Control Valve - Assemble
303.5E2, 304E2, 305.5E2 and 305E2 Mini Hydraulic Excavators Fuel Tank Cap and Strainer - Clean
365C Excavator Machine Systems Control Manifold (Pilot Oil) - Remove
365C Excavator Machine Systems Control Manifold (Pilot Oil) - Install
302.5C Mini Hydraulic Excavator Machine Systems Upper Frame and Undercarriage Frame - Connect
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
302.5C Mini Hydraulic Excavator Machine Systems Swing Gear and Bearing - Remove and Install
302.5C Mini Hydraulic Excavator Machine Systems Swing Motor - Disassemble
302.5C Mini Hydraulic Excavator Machine Systems Swing Motor - Assemble
365C Excavator Machine Systems Relief Valve (Pilot) - Install