The cab and the cab riser must be tilted in order to lower the overall height of the machine for shipping. A lifting device such as a crane is needed in order to tilt the cab.
Show/hide table
|
Do not tilt the cab when occupied. Before tilting the cab remove all loose articles from the cab, secure all windows and emergency exits, and then close the cab and cab riser doors. Failure to do so can result in personal injury or damage to the machine. |
|
Lower
Show/hide table
|
|
|
Illustration 1 | g00977572 |
Storage location for the cab support brackets inside the cab riser |
- Remove the cab support brackets. The brackets are used in order to brace the cab and the cab riser while the machine is being transported.
Show/hide table
|
|
|
Illustration 2 | g00612316 |
- Attach a suitable lifting device to the two lifting rings.
Note: The lifting rings are located in the top rear corners of the cab. The approximate weight of the cab, platform, and cab riser is 1700 kg (3750 lb).
Show/hide table
|
|
|
Illustration 3 | g01175993 |
Cab retention bolts for front of cab riser |
- Remove cab retention bolts (1) from the front of the cab riser compartment and install the cab retention bolts in weld nuts (3) .
Show/hide table
|
|
|
Illustration 4 | g01175923 |
Cab retention bolts for rear of cab riser |
- Remove cab retention bolts (2) from the rear of the cab riser compartment and install the cab retention bolts in weld nuts (3) .
Show/hide table
|
|
|
Illustration 5 | g00612251 |
Show/hide table
|
NOTICE |
Improper lifting or tiedowns can allow load to shift and cause injury or damage. |
|
Show/hide table
|
NOTICE |
Do not apply too much pressure with the lifting device being used. Damage to the riser frame may occur. |
|
- Move the cab riser until the cab riser is beyond the center point.
Show/hide table
|
|
|
Illustration 6 | g00612254 |
- Slowly lower the cab riser until the brackets can be installed, as shown.
Raise
Show/hide table
|
|
|
Illustration 7 | g00612254 |
- Attach a suitable lifting device to the two lifting rings.
Note: The lifting rings are located in the top rear corners of the cab. The approximate weight of the cab, platform, and cab riser is 1700 kg (3750 lb).
- Remove the cab support brackets.
Show/hide table
|
|
|
Illustration 8 | g00612251 |
Show/hide table
|
NOTICE |
Do not apply too much pressure with the lifting device being used. Damage to the riser frame may occur. |
|
- Raise the cab riser until the cab riser is beyond the center point.
- Slowly lower the cab riser until the cab riser is in the original position.
Show/hide table
|
|
|
Illustration 9 | g01175923 |
Cab retention bolts for rear of cab riser |
- Remove the cab retention bolts from the weld nuts (3). Install cab retention bolts (2) for the rear of the cab riser.
Show/hide table
|
|
|
Illustration 10 | g01175993 |
Cab retention bolts for front of cab riser |
- Remove the cab retention bolts from the weld nuts (3). Install cab retention bolts (1) for the front of the cab riser.
Show/hide table
|
|
|
Illustration 11 | g00612316 |
- Remove the lifting device from the cab.
- Install the brackets in the storage location inside the cab riser.