Usage:
Start By:
a. remove fuel injection lines
Fluid Spillage Containment
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to "Tools And Shop Products Guide", NENG2500 for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose fluids according to local regulations and mandates.
1. Remove bolt (1) and clamp (2) from the fuel injection nozzles to be removed.
2. Install Tool (A) with the inside lip of the puller on the lower stepped diameter of the fuel injection nozzle and the tip of the button in the threaded hole for bolt (1).
| NOTICE |
|---|
Do not exceed a torque of 17 N·m (150 lb in) on the screw in Tooling (A) during removal of the fuel injection nozzle. Added force can cause the stem of the fuel injection nozzle to bend or break off. |
3. Tighten the screw in Tooling (A) to a maximum torque of 17 N·m (150 lb in) to remove fuel injection nozzle (3).
4. If the fuel injection nozzle can not be removed with a maximum torque of 17 N·m (150 lb in) on the screw of Tooling (A), remove Tooling (A).
Typical Example
5. Remove the protective cap from fuel injection nozzle (3), and install Tooling (B) as shown.
| NOTICE |
|---|
Hold Tool (B) so the center line of the tool is in alignment with the centerline of fuel injection nozzle (3). This will prevent distortion of the fuel injection nozzle which can cause it to bend or break off during removal. |
6. Remove the fuel injection nozzle with Tool (B).
7. If Tool (B) was used to remove the fuel injection nozzle, make a replace of the fuel injection nozzle.
8. If Tool (A) was used to remove the fuel injection nozzle, remove the carbon dam seal on the end of the fuel injection nozzle.
Install Fuel Injection Nozzle
1. Use Tool (C) to clean the bore for the fuel injection nozzle. Use an open end wrench or tap driver to turn Tool (C).
2. Make reference to Special Instruction, SEHS7292, for the use of Tooling (D). Clean the fuel injection nozzle with Tooling (D).
3. Install a new seal (4) on fuel injection nozzle (3).
4. Put carbon dam seal (5) on the small end of Tool (E), and expand it by sliding it to the large end. Put Tool (E) against the fuel injection nozzle, and slide carbon dam seal (5) off Tool (E) on to the fuel injection nozzle. Slide the carbon dam seal into position in the groove on the fuel injection nozzle as shown.
5. Put fuel injection nozzle (3) in position in the cylinder head. Install clamp (2) and bolt (1) to hold the fuel injection nozzle in position.
End By:
a. install fuel injection lines