Atmospheric Pressure Sensor - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g00636417 |
Typical example |
- Disconnect plug (1) from atmospheric pressure sensor (2) .
- Remove atmospheric pressure sensor (2) and the O-ring seal.
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 2 | g00636417 |
Typical example |
Note: Check the condition of the O-ring seal. If the O-ring seal is worn or damaged, use a new part for replacement.
- Install the O-ring seal on the atmospheric pressure sensor (2) .
- Install atmospheric pressure sensor (2) and the O-ring seal. Tighten atmospheric pressure sensor (2) to a torque of 10 ± 2 N·m (88 ± 18 lb in).
- Connect wiring harness plug (1) to atmospheric pressure sensor (2) .
Caterpillar Information System:
G3500 Industrial Engines Engine Starts but Stalls Immediately
3500B and 3500B High Displacement Generator Set Engines Circuit Breaker
3406E and 3456 Industrial Engines Maintenance Interval Schedule
3608 Engine Cooling System Operation
3516B Generator Set Engines with Dynamic Gas Blending Starting System
3516B Generator Set Engines with Dynamic Gas Blending Charging System
3516B Generator Set Engines with Dynamic Gas Blending Electronic Circuits
3500 Engines with EUI Option Electrical System Operation
3512B Petroleum Engines Electric Starting System
3306B Industrial Engine Fuel Related Components in Cold Weather
3512 and 3516 EUI Engines for Caterpillar Built Machines Camshaft
G3304 and G3306 Engines Charging System
Electronic Modular Control Panel II+ (EMCP II+) Instrument Panel - For Non-Paralleling PEEC Engines
3176C and 3196 Marine Engines Bearing Clearance - Check
3176C and 3196 Marine Engines Camshaft - Remove
Electronic Modular Control Panel II+ (EMCP II+) Instrument Panel - For EUI Engines
G3304 and G3306 Engines Governor - Adjust
3176C and 3196 Marine Engines Camshaft - Install
3500B High Displacement Engines Engine Oil Pressure
3176C and 3196 Marine Engines Camshaft Bearings - Remove
3500B High Displacement Engines High Coolant Temperature
3500B High Displacement Engines Low Coolant Temperature
Electronic Modular Control Panel II+ (EMCP II+) Data Link
2000/04/01 A New Flexible High Pressure Oil Supply Hose Assembly Is Used In The Hydraulic Electronic Unit Injector (HEUI) Fuel System {1307, 1714}