01 No Speed Sensor Signal (Open)
Conditions Which Generate This Code:
Show/hide table
 | |
| Illustration 1 | g00664421 |
One of the following conditions exist:
- The signal wire is open between the sensor and the Timing Control Module (TCM).
- The ground wire is open between the -battery and the sensor ground.
- The resistance of the sensor is greater than 800 ohms.
- The TCM has failed.
System Response:
The engine will not run due to no ignition. No magneto clock signal is sent to the Magneto Interface Box (MIB) from the TCM. If the signal is not present, the MIB will not fire the magneto. The TCM will activate the outputs for the shutdown indicator and the remote indicator. The "NO SPEED SENSOR" LED will illuminate. The code may be viewed on the DDT.
Test Step 1. Perform the following test: Speed Sensor (Open Circuit)
Results:
- OK - Stop.
Caterpillar Information System:
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0446 - FMI 06 Air Shutoff Relay short
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0446 - FMI 05 Air Shutoff Relay open
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0444 - FMI 06 Start Relay short to ground
G3612 and G3616 Engines Idler Gears (Rear) - Install
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0338 - FMI 06 Pre-Lube Relay short to ground
3608 Engine Fuel Injector Synchronization
3512B Petroleum Engines with the ADEM 2 Electronic Control Module MID 036 - CID 0337 - FMI 02 Incorrect Remote E-Stop Switch inputs
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0289 - FMI 04 Unfiltered Fuel Pressure short to ground
3608 Engine Fuel Injector Timing
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0094 - FMI 13 Fuel Pressure calibration required
G3612 and G3616 Engines Idler Gears (Rear) - Remove
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0094 - FMI 04 Fuel Pressure short to ground
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0542 - FMI 03 Unfiltered Engine Oil Pressure open/short to +batt
TK741, TK751 and TK752 Track Feller Bunchers Machine Systems Duo-Cone Conventional Seals - Install
G3500 Industrial Engines 02 No Speed Sensor Signal (Short)
3608 Engine Woodward EGB13P Governor
G3500 Industrial Engines 03 No Crank Angle Sensor Signal (Open)
G3500 Industrial Engines 04 No Crank Angle Sensor Signal (Short)
G3500 Industrial Engines 05 No Magneto Interface Signal
G3500 Industrial Engines 06 No Right Detonation Sensor Signal
G3500 Industrial Engines 07 No Left Detonation Sensor Signal
Uninterruptible Power Supply (UPS) 250 Lower Bearing - Remove and Install
G3500 Industrial Engines 08 Magneto Out of Calibration
3608 Engine Fuel Setting