MID 036 - CID 0446 - FMI 06 Air Shutoff Relay short
产生此代码的情况:
电子控制模块（ECM）检测到对接地短路。 ECM 只能在空气关断继电器未通电时检测到此状态。
系统响应:
CID-FMI 记录在存储器中。
测试步骤 1.
结果:
- 正常 - 停止
- 经修理后合格 - 停止
Caterpillar Information System:
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0446 - FMI 05 Air Shutoff Relay open
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0444 - FMI 06 Start Relay short to ground
G3612 and G3616 Engines Idler Gears (Rear) - Install
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0338 - FMI 06 Pre-Lube Relay short to ground
3608 Engine Fuel Injector Synchronization
3512B Petroleum Engines with the ADEM 2 Electronic Control Module MID 036 - CID 0337 - FMI 02 Incorrect Remote E-Stop Switch inputs
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0289 - FMI 04 Unfiltered Fuel Pressure short to ground
3608 Engine Fuel Injector Timing
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0094 - FMI 13 Fuel Pressure calibration required
G3612 and G3616 Engines Idler Gears (Rear) - Remove
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0094 - FMI 04 Fuel Pressure short to ground
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0094 - FMI 03 Fuel Pressure open/short to +batt
G3500 Industrial Engines 01 No Speed Sensor Signal (Open)
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0542 - FMI 03 Unfiltered Engine Oil Pressure open/short to +batt
TK741, TK751 and TK752 Track Feller Bunchers Machine Systems Duo-Cone Conventional Seals - Install
G3500 Industrial Engines 02 No Speed Sensor Signal (Short)
3608 Engine Woodward EGB13P Governor
G3500 Industrial Engines 03 No Crank Angle Sensor Signal (Open)
G3500 Industrial Engines 04 No Crank Angle Sensor Signal (Short)
G3500 Industrial Engines 05 No Magneto Interface Signal
G3500 Industrial Engines 06 No Right Detonation Sensor Signal
G3500 Industrial Engines 07 No Left Detonation Sensor Signal
Uninterruptible Power Supply (UPS) 250 Lower Bearing - Remove and Install
G3500 Industrial Engines 08 Magneto Out of Calibration