Engine Oil Filter Base - Disassemble
Disassembly Procedure
Start By:
- Remove the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Remove".
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove engine oil filter (1) from engine oil filter base (2) .
Show/hide table
 | |
| Illustration 1 | g00762619 |
- Loosen threaded adapter (4) from oil cooler (3) (if equipped).
- Remove oil cooler (3) from engine oil filter base (2), if necessary.
- Clean threaded adapter (4) that holds oil cooler (3) in position. Inspect the condition of washer (7). If washer (7) is worn or damaged, use a new part for replacement.
Show/hide table
 | |
| Illustration 2 | g00664208 |
- Inspect the condition of seals (5) and (6). If the seals are worn or damaged, use new parts for replacement.
Caterpillar Information System:
G3500 Industrial Engines Engine Misfires, Runs Rough or Is Unstable
3054B Industrial Engine Engine Oil Filter Base - Install
3054B Industrial Engine Engine Oil Filter Base - Remove
G3500 Industrial Engines Engine Cranks but Will Not Start
G3500 Industrial Engines Engine Will Not Crank
3608 Engine Fuel Injector Testing
G3500 Industrial Engines Symptoms
3608 Engine Fuel Pressure
1999/12/06 New Service Magazine Format {0374, 1000, 7000}
3512B Petroleum Engines with the ADEM 2 Electronic Control Module Factory Passwords Worksheet
3608 Engine Grounding Practices
3608 Engine Manual Barring Group
G3500 Industrial Engines Engine Shutdown
3608 Engine Camshaft Timing
G3500 Industrial Engines Engine Timing Does Not Match Programmed Timing
G3500 Industrial Engines Intermittent Engine Shutdown
G3500 Industrial Engines DDT Does Not Communicate with the TCM System
G3500 Industrial Engines Diagnostic Codes
1999/12/20 Change to Tightening Procedure for Cylinder Head Bolts in Specifications, RENR1217 and Specifications, SENR5182 {1100}
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0261 FMI 13 Engine Timing Calibration required
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0001 FMI 05 Cylinder #1 Injector open circuit
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0001 FMI 06 Cylinder #1 Injector short
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0002 FMI 05 Cylinder #2 Injector open circuit
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0003 FMI 05 Cylinder #3 Injector open circuit