Special Instruction, REHS1238, "Obtaining Factory Passwords and Software Enabled Attachments" is Available {7610}
- Caterpillar Products: with Electronic Control Modules that Use Flash Programming
- All
Reference: Special Instruction, REHS1238, "Obtaining Factory Passwords and Software Enabled Attachments"
The revised Special Instruction, REHS1238 provides the following information:
- Process of determining the price of an attachment feature
- Process of ordering an attachment feature
- Process of installing an attachment feature
The revised Special Instruction, REHS1238, "Obtaining Factory Passwords and Software Enabled Attachments" is available through normal Literature ordering channels. This revised Special Instruction is also available for electronic distribution in the Service Information System (SIS).
Caterpillar Information System:
2003/02/03 A New Electronic Controller for the Air Inlet Heater (AIH) Improves the Engine Starting Ability {1090}
321C CR Excavator Hydraulic System Relief Valve (Line) - Test and Adjust
321C CR Excavator Hydraulic System Relief Valve (Crossover) - Test and Adjust
321C CR Excavator Hydraulic System Relief Valve (Main) - Test and Adjust
G315, G320 and G330 Demolition and Sorting Grapples Reference Material
321C CR Excavator Hydraulic System Relief Valve (Pilot) - Test and Adjust
G315, G320 and G330 Demolition and Sorting Grapples Transport Position
3054E Industrial Engine Fuel Priming Pump and Fuel Filter Base - Remove and Install
321C CR Excavator Hydraulic System Cylinder Speed - Check
321C CR Excavator Hydraulic System Cylinder Drift - Check - Loaded Bucket
321C CR Excavator Hydraulic System Swing Speed and Overswing on Level Ground - Check
321C CR Excavator Hydraulic System Travel on Level Ground - Test - Optional Test
325C Excavator Safety Messages
Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070} Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070}
325C Material Handler Hydraulic System Boom Hydraulic System
365B, 365B Series II and 365BL Excavators Cooling System Coolant Sample (Level 1) - Obtain
365B, 365B Series II and 365BL Excavators Cooling System Coolant Sample (Level 2) - Obtain
325C Material Handler Hydraulic System Stick Hydraulic System
321C CR Excavator Hydraulic System Relief Valve (Swing) - Test and Adjust
325C Material Handler Hydraulic System Grapple Hydraulic System
3054E Industrial Engine Engine Oil Filter Base - Remove and Install
345B Series II Material Handler Specifications
321C CR Excavator Hydraulic System Swing Motor - Test - Measurement of Case Drain Oil
3054E Industrial Engine Engine Oil Cooler - Remove