Specifications
Show/hide table
Illustration 1 | g00702812 |
Show/hide table
345B Series II Material Handler (1)     | |
Approximate Weight (2)     | 53085 kg (117032 lb)     |
Operating Weight     | 55982 kg (123420 lb)     |
Overall Length (A)     | 13550 mm (44 ft 6 inch)     |
Shipping Height (B)     | 3350 mm (10 ft 8 inch)     |
Overall Width (C)     | 3970 mm (12 ft 8 inch)     |
Track Shoe Width (D)     | 750 mm (2 ft 6 inch)     |
Show/hide table
( 1 ) | These specifications are obtained by the removal of the following components for shipping purposes: the walkways, the hand rails and the exhaust extension. |
( 2 ) | This specification is for a machine that has a 10 percent full fuel tank. |
Consult your Caterpillar dealer for specifications that are not included in table 1.
Caterpillar Information System:
3054E Industrial Engine Engine Oil Filter Base - Remove and Install
325C Material Handler Hydraulic System Grapple Hydraulic System
321C CR Excavator Hydraulic System Relief Valve (Swing) - Test and Adjust
325C Material Handler Hydraulic System Stick Hydraulic System
365B, 365B Series II and 365BL Excavators Cooling System Coolant Sample (Level 2) - Obtain
365B, 365B Series II and 365BL Excavators Cooling System Coolant Sample (Level 1) - Obtain
325C Material Handler Hydraulic System Boom Hydraulic System
Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070} Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070}
325C Excavator Safety Messages
2003/02/03 Special Instruction, REHS1238, "Obtaining Factory Passwords and Software Enabled Attachments" is Available {7610}
2003/02/03 A New Electronic Controller for the Air Inlet Heater (AIH) Improves the Engine Starting Ability {1090}
321C CR Excavator Hydraulic System Relief Valve (Line) - Test and Adjust
321C CR Excavator Hydraulic System Swing Motor - Test - Measurement of Case Drain Oil
3054E Industrial Engine Engine Oil Cooler - Remove
3054E Industrial Engine Engine Oil Cooler - Install
325C Material Handler Hydraulic System Relief Valve (Line) - Test and Adjust
C13, C15, and C18 Tier 4 Final Engines Water Pump
Procedure for the Repair of the Compensating Valves in the Main Hydraulic Control Valve{5051, 5086} Procedure for the Repair of the Compensating Valves in the Main Hydraulic Control Valve{5051, 5086}
3054E Industrial Engine Water Pump - Remove and Install
320C Excavator Machine System Specifications Pilot Lines
320C Excavator Machine System Specifications Pilot Lines
Supplement to the Operation and Maintenance Manual{0707} Supplement to the Operation and Maintenance Manual{0707}
322C Excavator Capacities (Refill)
M318C Wheeled Excavator Machine System Pressure Switch (Air)