Transport Position
Show/hide table
NOTICE |
---|
For specific information on your host machine, refer to the Operation and Maintenance Manual of your host machine. |
When you transport the Grapple on the host machine, position the Grapple so the stick can be moved under the boom and the boom can be carried as low as possible.
Show/hide table
Illustration 1 | g00622787 |
When you must transport the Grapple on another vehicle, position the Grapple with the jaws in the open position. Position the Grapple with the jaws flat on the bed of the vehicle.
Caterpillar Information System:
3054E Industrial Engine Fuel Priming Pump and Fuel Filter Base - Remove and Install
321C CR Excavator Hydraulic System Cylinder Speed - Check
321C CR Excavator Hydraulic System Cylinder Drift - Check - Loaded Bucket
321C CR Excavator Hydraulic System Swing Speed and Overswing on Level Ground - Check
321C CR Excavator Hydraulic System Travel on Level Ground - Test - Optional Test
321C CR Excavator Hydraulic System Engine Performance - Test - Engine Speed
321C CR Excavator Hydraulic System Operational Checks
G315, G320 and G330 Demolition and Sorting Grapples Cutting Edges - Inspect/Replace
G315, G320 and G330 Demolition and Sorting Grapples Bushings (Work Tool Arms) - Lubricate
G315, G320 and G330 Demolition and Sorting Grapples Bearings (Cylinder Ends) - Lubricate
3054E Industrial Engine Piston Cooling Jets - Remove and Install
320B, 320B L and 320B N Excavators Swing Drive Oil Sample - Obtain
321C CR Excavator Hydraulic System Relief Valve (Pilot) - Test and Adjust
G315, G320 and G330 Demolition and Sorting Grapples Reference Material
321C CR Excavator Hydraulic System Relief Valve (Main) - Test and Adjust
321C CR Excavator Hydraulic System Relief Valve (Crossover) - Test and Adjust
321C CR Excavator Hydraulic System Relief Valve (Line) - Test and Adjust
2003/02/03 A New Electronic Controller for the Air Inlet Heater (AIH) Improves the Engine Starting Ability {1090}
2003/02/03 Special Instruction, REHS1238, "Obtaining Factory Passwords and Software Enabled Attachments" is Available {7610}
325C Excavator Safety Messages
Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070} Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070}
325C Material Handler Hydraulic System Boom Hydraulic System
365B, 365B Series II and 365BL Excavators Cooling System Coolant Sample (Level 1) - Obtain
365B, 365B Series II and 365BL Excavators Cooling System Coolant Sample (Level 2) - Obtain