User Defined Shutdown Input
The electronic control module (ECM) reads this switch input. The ECM will terminate the fuel injection if the input is connected to the chassis ground. The shutdown is permanently recorded in the ECM as a logged event.
Caterpillar Information System:
C-12 Truck Engine General Information
3508B Engine for Caterpillar Built Machines Atmospheric Pressure Sensor
3508B Engine for Caterpillar Built Machines Engine Speed/Timing Sensor
3508B Engine for Caterpillar Built Machines Permanent Timing Calibration Sensor
C280 Marine Engines Air Shutoff
3608 Engine Aftercooler
3114, 3116 and 3126 MUI Engine Governors Governor (Types I, II, and Some III) - Adjust
3608 Engine Air Inlet and Exhaust System Operation
C-12 Engine Cold Start Strategy
G3304 and G3306 Engines Ignition System
3176C and 3196 Engines for Caterpillar Built Machines Engine Oil Temperature Is Too High
1999/12/01 Torque Increased for Nuts on Fuel Injector Wiring Harness {1290}
3508B Engine for Caterpillar Built Machines Fuel Injector Timing
3508B Engine for Caterpillar Built Machines Pressure Sensor for Turbocharger Compressor Inlet
3508B Engine for Caterpillar Built Machines Pressure Sensor for Turbocharger Compressor Outlet
3608 Engine Lubrication Metering Pump - Remove and Install
3608 Engine Internal Lubrication
3512B Marine Auxiliary Engine Monitoring System
3512 and 3516 EUI Engines for Caterpillar Built Machines Electronic Control Circuit for the Fuel System
3500B and 3500B High Displacement Generator Set Engines Fuel Injector Mechanism
3508B Engine for Caterpillar Built Machines Electronic Fuel Injector
3500B and 3500B High Displacement Generator Set Engines Air Inlet and Exhaust System Operation
2000/02/01 A New Sensor Housing In Prelubrication Lines Groups (Continuous Prelube) Provides Improved Operation {1319}
3500B and 3500B High Displacement Generator Set Engines Aftercooler