3508B Engine for Caterpillar Built Machines Caterpillar


Permanent Timing Calibration Sensor

Usage:

854G 1JW
This sensor is used to calibrate the top center (TC) position as the position is seen by the engine speed/timing sensor. The sensor is installed in the TC port. The port is located on the flywheel housing. The Caterpillar Electronic Technician (ET) compares the signal from the sensor from the signal from the engine speed/timing sensor. Make any adjustments that are needed to the reference point that is used. Make these adjustments with the use of the electronic control module (ECM).

Caterpillar Information System:

C280 Marine Engines Air Shutoff
3608 Engine Aftercooler
3114, 3116 and 3126 MUI Engine Governors Governor (Types I, II, and Some III) - Adjust
3608 Engine Air Inlet and Exhaust System Operation
C-12 Engine Cold Start Strategy
G3304 and G3306 Engines Ignition System
3176C and 3196 Engines for Caterpillar Built Machines Engine Oil Temperature Is Too High
1999/12/01 Torque Increased for Nuts on Fuel Injector Wiring Harness {1290}
3508B Engine for Caterpillar Built Machines Engine Overspeed Control
3114, 3116 and 3126 MUI Engine Governors Governor (Type VII) - Check
3114, 3116 and 3126 MUI Engine Governors Governor (Type VI) - Check
3508B Engine for Caterpillar Built Machines Fuel Filter Restriction
3508B Engine for Caterpillar Built Machines Engine Speed/Timing Sensor
3508B Engine for Caterpillar Built Machines Atmospheric Pressure Sensor
C-12 Truck Engine General Information
3508B Engine for Caterpillar Built Machines User Defined Shutdown Input
3508B Engine for Caterpillar Built Machines Fuel Injector Timing
3508B Engine for Caterpillar Built Machines Pressure Sensor for Turbocharger Compressor Inlet
3508B Engine for Caterpillar Built Machines Pressure Sensor for Turbocharger Compressor Outlet
3608 Engine Lubrication Metering Pump - Remove and Install
3608 Engine Internal Lubrication
3512B Marine Auxiliary Engine Monitoring System
3512 and 3516 EUI Engines for Caterpillar Built Machines Electronic Control Circuit for the Fuel System
3500B and 3500B High Displacement Generator Set Engines Fuel Injector Mechanism
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.